Lords of the Ring

[bolt]

The control circuit on his smallest TPU was very small. I recon 4 IC and perhaps handful of transistors/fets not much at all.  The TPU must have a battery although this could be tiny. A 12 volt battery that is used in car remote alarm fobs is perfect clipped to one end of the PCB. Wrap all this in black tape against the side of the coil and no one knows its there. The battery is only used to start the PLL local oscillators which wont draw more then about  50 / 80 mA. Remember no jack hammer power needed here only purity. Also note this device is sensitive to anything in the middle of the collector and what side up it runs. Although bench testing may work thrown together the final tweaks have to be done with everything in situ.
As soon as the TPU is running a few windings off the coil will collect ample power to drop through 2 diodes and a small cap to take over the control PSU. Thats the least of our problems though!

What i think we need now is suggestions for the frequency generation, ideas who knows of a nice IC to work with zero PPM error maybe PLL and post some circuits showing the generation of the 3 frequencies which appear to be uncanny close to design concept.  555's are out they are as sloppy as a pig.  Someone needs to be tooled up ready and prepared to do this. Unfortunately i cant at the mo just don't have access to the test stuff i used to have in the past although i will do soon if others have lost interest.

In order to produce the heterodyne offset i think make 2 of the gens then test first with pure sine then overlay one for each frequncy with the offsets.

Then need 3 comparators which look at the feedback control coils.A diode hanging off these maybe enough almost like an RF sniffer because the pulse now is NOT audio its our first little kick and its very very small perhaps only a few uV.  Low noise high gain comparators essential.  We need to think of ways that when the pulse is seen in the next segment the comparators react very fast in turning off and on our frequencies. PIN diodes may work well here rather than controlling the IC that maybe too slow.  These have to come up to full sine voltage in one wave with no preamble or i don't think it will work.

The problem is there is so much information on this thread about coil construction i really dont know how to collate it all. 99.9% is garbage though but there is 0.1% thats extremely useful.

[innovation_station]

here is a link i just found and it might have some intresting stuff  in it

http://www.4timing.com/techcrystal.htm

ist

[bolt]

Here is a very serious question. I am sure this has been asked before. What will you do if you make this thing work? Suddenly after 2 years of sod all the tpu burst into life and runs 4 light bulbs full brightness with nothing more then a pp3 on the input. Its a very serious one because you know that it could change everything on this planet. Its a big as the internal combustion engine.  Billions of people still have no power and millions more live off a car battery. On the flip side you want something for your efforts. I don't think patents would apply here either because there is nothing to copy from. Its like the Microsoft IBM scenario where they sat in a room with a blank bit of paper and made a PC even though it was known roughly how to make one it wasn't copied. (apparently) I don't know even how i would react everyone says "oh yea i will share it" but its more than even winning the lottery. Then there is the risk of MIB popping round. Who says they couldn't be sold or as SM did sell out to the highest bidder. For most inventors its by far the most comfortable route. MIB are happy, world industry not disturbed, and you get 100 MIO to live happy every after. I'm not saying this is the right thing to do but people are basically greedy and thats life.

[innovation_station]

Here is a very serious question. I am sure this has been asked before. What will you do if you make this thing work?

well i would build a few and help out a few friends to save some money  maybe hook it up to some battery banks to power there house or hey maybe some free heat just in time for christmas 

it is totaly unlimited what you could do

the question is......                  do we deserve it??

william

[Mannix]

Here is a very serious question. I am sure this has been asked before. What will you do if you make this thing work? Suddenly after 2 years of sod all the tpu burst into life and runs 4 light bulbs full brightness with nothing more then a pp3 on the input. Its a very serious one because you know that it could change everything on this planet. Its a big as the internal combustion engine.  Billions of people still have no power and millions more live off a car battery. On the flip side you want something for your efforts. I don't think patents would apply here either because there is nothing to copy from. Its like the Microsoft IBM scenario where they sat in a room with a blank bit of paper and made a PC even though it was known roughly how to make one it wasn't copied. (apparently) I don't know even how i would react everyone says "oh yea i will share it" but its more than even winning the lottery. Then there is the risk of MIB popping round. Who says they couldn't be sold or as SM did sell out to the highest bidder. For most inventors its by far the most comfortable route. MIB are happy, world industry not disturbed, and you get 100 MIO to live happy every after. I'm not saying this is the right thing to do but people are basically greedy and thats life.

Bolt!

Thats the first unproductive  post you have made.
Politics does not belong here...GK might disagree in which case I do apolagise.

read the first page of "master of magnetics"

Lindsay