Lords of the Ring

[FatBird]

I re-watched SM's 9 minute Video & his 38 Minute video & wrote down all of the TPU stats that he mentioned.  Maybe this will help us get some more clues as to NUMBER of LEVELS, FREQUENCIES, DIMENSIONS, etc?  For example, can 3 or 4 Levels really fit into a TOTAL HEIGHT of only 2 inches?  Personally, I don't think so.

============================================
12 Ounce OPEN COIL.

OD = 6 inches.
Height = 2 inches.
Thickness = 1 inch.
Output = 186V @ 5 Amps.  7 Amps with a Heat Sink.

============================================

Small 1 Pounder, OPEN COIL.  Took Magnet from his pocket.

OD = 4 inches.
Height = 1 3/4 inches.
Output = 100V @ 1 Amp.  7.3 Hz & 5 KHz.

=================================

Small Open Coil, 1 1/2  Pounder:

OD = 6 inches.
Height = 2 inches.
Thickness = 3/4 inches.
Output = 120V @ 5 Amps.  7.3 Hz & 5 KHz.

=================================

Large 17" Open Coil.

OD = 17 inches.
Height = 3 inches.
Thickness =
Output = 830V @ 10 Amps.

=================================


.

[innovation_station]

.

[innovation_station]

.

[innovation_station]

.

[giantkiller]

@IS
I understand your directions and points well made. Right now we are going in cheap, small and dirty(And this really is no joke! Paper rolls, pop bottles and duct tape). The tune up and showboat specs can come later. It doesnt hurt to keep the steps small. They have been very fast coming since I got the kicks. Alot of people have posted tremendous facts and information. Everything has gotten alot of attention worldwide and all of us fit in at a perfect place. As long as you posted you specs or desires they can be taken into consideration. Believe me. I have followed everything here and before. And what I had posted came true. Yours will too. This is a great adventure.

--giantkiller.

about the cheep small dirty

how will you achive the proper operation of this unit in my opinoin with out proper coils?

the entire unit is cheep small dirty

have you not been trying for 1.5 years now with the 3 rings with a laque of good results?

is

The proper operation will be a later step. We still run under a power source.

This step is the tuning step.

No Sir. I have only been on this section of the project for 90 days. I have been on this site and others since Sept 2006.

Now what I would like show here is a model of the pulse timimg.
The red spikes are the pulses / kicks. The yellow cylinders are the control coils. The green line is the collector.
What is shown here is where the pulses hit when the frequency is a 4:1 match with the length of the collector which equates to the circumference, hence the diameter. Harmonics can also be used to circumnavigate around the ring to the step of 1/5, 1/9, 1/13, 1/17 to get a pulse at the next control coil with a slower and slower frequency. This is important. That frequency chosen has got to be in resonance with the control coil specifications. The freqency chosen has also got be slower than the collapse of the field. This would allow the cavitation energy spoken about by Dale Pond. This action also gives the operation a rotational sequencing using 1 frequency.

RFC.

--giantkiller. In a nutshell.