High voltage HHO by IronHead

[IronHead]

@Moab,
your system is a completely different one than the onefrom IronHead.
Did you see the videos of IronHead yet on Youtube from the above links ?


IronHeadÃ,´s system produces so much more gas, that it is increadible,
if it is really done only with 90 Volts DC and 0.2 Amps= 18 Watts ?

If this gas is really HHO ( oxyhydrogen ) and not just steam or CO or CO2
(maybe because of his baking soda ?) ,
then it is really an amazing production rate !

IronHead, maybe you just can put via a hose and a bubbler your device
under test again and light a few bubbles coming from the bubbler water
and show the Voltage on  voltmeter and the amps on an ampmeter.

Did you also use any special pulsing for it ?

Many thanks.

There is no baking soda in this system . The only place I talked about baking soda was on the "ColdFusion reactor.This Cell is tap water. It is because of High voltage ,
its is because of  the right temperature , Materials , It is charging water and waiting for the reaction over time. and the freqs we have not talked about yet.  you know about one of the freqs 120hz.

No level of HHO is to low. Evolution is the road to success.
Just Build It
   IronHead

[Moab]

Yes i did see the videos. I surely havnt made gas like that. Ironhead has not gone in to to much detail yet, Give him time. He is probably waiting for the new thread to settle down abit. Congrats on your thread Ironhead. And i havnt been messing aroung with HHO vary long, Its a distraction from the TPU for me. But i would bet my favorite hat that he is pulsing and flipping polarity at a given frequency and rate. I dont see how you could get that much gas without it being pure hydrogen poroxide and bakeing soda. without pulsing or fliping,, Just a thought.

Lets build it!
    Moab

[IronHead]

Yes both

[Moab]

Wahoo! Great

Now if i can make a simple flipflop. And freq pulser from 120v-60hz. we are in! Hmm where have i seen this before? hmmmm,, and its gotta run from an inverter. Or maybe even a seporate alternator that is modified to do this vary thing. Now where did i put that circuit??



              Lets Build it !              Like my new saying?   Moab

[IronHead]

If you are full wave rectifying 60hz from the wall 115/120vac you will get 120 Hz

Flip like this at negative prim  ------ + ------ + ------- +     
Every second Negative and Positive a millisecond . you got to play with it.
Again I am not a scientist

If you go fast  you will dissolve the tungsten.SS on SS you will have no problems
of dissolving.

Pulse is from 19k to 22k the wave should be sharp.

You have to tune it. be patient between hz as there is a lag time.