Overunity.com Archives is Temporarily on Read Mode Only!


Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
You also can visit us or register at my main site at:
Overunity Machines Forum



Talking about phase...

Started by bob.rennips, July 01, 2007, 08:16:56 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 ... 18 19 20 21 22 ... 25
User actions

gn0stik

#95
July 19, 2007, 02:58:46 PM
Silver coated ezflow wire can be found in high end automotive audio stores.

Bruce_TPU

#96
July 22, 2007, 12:59:28 PM
Hello all,

Here are some sources for silver plated copper solid wire.  I would suggest not ordering yet, until we have a gauge or suggested range of gauges, as it is very pricey.  Unless money is no matter to you.  ;)

Thank you Jason and Grumpy for your help in sourcing this information:
http://cgi.ebay.com/CRAFT-30-YARD-OF-24ga-SILVERED-WIRE-METALWORK_W0QQitemZ8174749479QQihZ 020QQcategoryZ41224QQrdZ1QQssPageNameZWD1VQQcmdZViewItem
http://cgi.ebay.com/Silver-Coated-Beading-Wire-Tiger-Tail-38mm_W0QQitemZ220131859114QQihZ0 12QQcategoryZ67718QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
http://www.alphawire.com/pages/254.cfm

Mil spec number for Teflon coated solid copper wire with silver plating is MIL-W-16878 - Google this and you get plenty of hits.   This place carries it:  http://www.weicowire.com/specpage.asp?nGroupID=190   I recommend searching for surplus - stuff ain't cheap.   PTFE is "Teflon".  FEP is very similar compound.  The silver plating is what matters.   
1.  Lindsay's Stack TPU Posted Picture.  All Wound CCW  Collectors three turns and HORIZONTAL, not vertical.

2.  3 Tube amps, sending three frequency's, each having two signals, one in-phase & one inverted 180 deg, opposing signals in each collector (via control wires). 

3.  Collector is Magnetic Loop Antenna, made of lamp chord wire, wound flat.  Inside loop is antenna, outside loop is for output.  First collector is tuned via tuned tank, to the fundamental.  Second collector is tuned tank to the second harmonic (component).  Third collector is tuned tank to the third harmonic (component)  Frequency is determined by taking the circumference frequency, reducing the size by .88 inches.  Divide this frequency by 1000, and you have your second harmonic.  Divide this by 2 and you have your fundamental.  Multiply that by 3 and you have your third harmonic component.  Tune the collectors to each of these.  Input the fundamental and two modulation frequencies, made to create replicas of the fundamental, second harmonic and the third.

4.  The three frequency's circulating in the collectors, both in phase and inverted, begin to create hundreds of thousands of created frequency's, via intermodulation, that subtract to the fundamental and its harmonics.  This is called "Catalyst".

5.  The three AC PURE sine signals, travel through the amplification stage, Nonlinear, producing the second harmonic and third.  (distortion)

6.  These signals then travel the control coils, are rectified by a full wave bridge, and then sent into the output outer loop as all positive pulsed DC.  This then becomes the output and "collects" the current.

P.S.  The Kicks are harmonic distortion with passive intermodulation.  Can't see it without a spectrum analyzer, normally unless trained to see it on a scope.

Super God

#97
July 22, 2007, 08:28:08 PM
Quote from: starcruiser on July 19, 2007, 01:01:16 PM
Quote from: Super God on July 19, 2007, 10:21:01 AM
I've taken pictures of mine, it's all wound and everything, the collectors, bias, and controls.  Just figuring out a good oscillator plan with the tubes I'm going to order eventually (money issues)

Why not try a simple blocking oscillator design using a small torrid from a PC power supply and tap that for your open ended primaries? I recall reading that you can build 2 blocking osc and have one track the other and by adjusting the time constant of one you can create a simple frequency divider which is sync'd.

here a a couple of sites that might be interesting to review.

http://139.134.5.123/tiddler2/c0508/block.htm

http://home.att.net/~pldexnis/CTC2_how_it_works/blocking_oscillator.html

http://www.vias.org/eltransformers/lee_electronic_transformers_11_01.html

http://www.electronic-circuits-diagrams.com/psimages/powersuppliesckt6.shtml

http://www.du.edu/~etuttle/electron/elect37.htm
I don't understand the blocking oscillator.  Could someone explain what it would do?  Does it just block out the negative cycle of a wave?
>9000

Bob Boyce

#98
July 23, 2007, 06:08:56 PM
Looks like my open posts here need to end. The water for fuel crowd have begun to link here in the misguided impression that the RMF device is the same as the lower energy version that was designed specifically for the waterfuel application. I do not want to be responsible for encouraging the wrong kind of experimenters into dabbling with dangers they do not comprehend. I was afraid that this would happen. Those advanced enough in the art to experiment safely with this can continue to communicate with me via email or PM.

Bob Boyce

Grumpy

#99
July 23, 2007, 07:37:29 PM
Thanks much Bob.

It is the men of insight and the men of unobstructed vision of every generation who are able to lead us through the quagmire of a in-a-rut thinking. It is the men of imagination who are able to see relationships which escape the casual observer. It remains for the men of intuition to seek answers while others avoid even the question.
                                                                                                                                    -Frank Edwards
Print
Go Up Pages 1 ... 18 19 20 21 22 ... 25
User actions