Stanley Meyer replication with low input power

[saintpoida]

More questions

These are probably basic as well but anyway

Would the fet need protection from anything coming back from the inductor(s)?
And if so what? A chunky diode maybe?

Im assuming something comes back and thats why it can handle 200v?

Thanks again

[Spewing]

im not sure what your asking on the fet, if you're asking me i didn't have any problems with it. also i'm not trying to get overunity anymore, i am more focused on finding the cell with the best output straight dc.

i was so lost trying to find overunity i forgot the real reason to produce hydrogen, and thats to produce enough to run a car HOD. so i have decided to forget about over unity and start looking for something that was possible. i came to the conclusion that if you find the right cell you will be replacing the water in it as it is consumed by the engine, therfor if a cell is running a car it always will have moving water and you want have a heat issue.

[saintpoida]

yeah i dunno what im asking either, i was only asking whoever could answer really lol

i just figured that if im pulsing the cell and its gonna get bigger until resonance, then surely
there will be some sort of back lash towards the circuit itself if that makes sense...

in relation to overunity and cars, yeah my objective is to get it in a car too, while i dont really
care for overunity it would still be nice to achieve, either way the car is the goal

regards

[dutchy1966]

More questions

These are probably basic as well but anyway

Would the fet need protection from anything coming back from the inductor(s)?
And if so what? A chunky diode maybe?

Im assuming something comes back and thats why it can handle 200v?

Thanks again

Hi Saintpoida,

As far as I know there shouldn't be anything coming back from the inductor because of the blocking diode in the circuit. It only allows current in the directions of the cell! Of couse that diode needs to be able to handle the voltage biut i think if you used the "standard" 1n4007 it should be alright.

Also your inductor looks nice! Good work. You will need two of them right? (or one bifilar wound one).

For everyone who hasn't read it I've attached the patent from Stanley where Lawtons/Ravz replication is based on. I strongly suggest reading it because it clears up a whole lot of misconceptions.

I'm still awaiting delivery of my acrylic tube. As soon as that arrives I will replicate Ravz replication 

cheers

Robert

[saintpoida]

Thanks dutchy

yeah i have the 1n4007 diode and that inductor is bifilar wound (i hope lol)

two wires side by side is bifilar right??

i still need to order my acrylic yet but i have a bin that im using for conditioning
the rust has seemed to slow down a fair bit now and im also hardly producing brown crud anymore
except on the low amperage, i will see if brown stuff returns when i clean up the outer tubes a bit

when i stop the crud i will put the inductor in and see if that brings back the crud