TPU - General Discussion

[poynt99]

@grumpy,

yes i thought along those lines.

if spherics is/was correct about the iron delay coil, comp field, and all in general, and was not feeding us bullshit, then i could see an iron coil being wound under the kick coil layer, or it could be wound on the inner core shown inside the leg. again, assuming the spherics posts are true, i believe the method SM eventually used to bring the iron delay coil close in proximity to the kick coils was to use a permanent magnet bias near them. so this would come either from the activation magnet placed on top, or maybe there is a cylindrical permanent magnet inside the leg.

@ ist,

yes i drew this myself, thanks.

the idea for me is to maintain the 90 degree coil relationship, AND reveal where the control and collector coils are. this is the only way i can fullfill all the requirements. remember the idea is to create a mess of frequencies within the space of the collector so that it can amount to many combined kicks being dissipated there as output power.

@vortex1

thanks. i drew this with sketchup 6. it is fairly easy i guess. they have good tutorials to help you learn. there is a free version.

it's so hard to say where the speaker wires and white wires go to. if the white wires go to the output, then maybe that is for feedback, but that may not be right either. it would be great to see where the red speaker wire(s) terminate. it's a tough one, and i am using simple logic to try and figure out the most likely configuration based on all i know about this device and the others.

i can't see the kick coils in my diagram actually being the collector, but it's possible.

[innovation_station]

@poynt99

it must be the collector .....


as sm says the source becomes the supply....   it is like a furnice wich fuels its self  so the input must be limited by a cap ...  the excess is output??

ist

[zrad]

Hi All,

I am new to this forum but am a researcher and technologist of a diverse scientific background.

Thanks for your input from your posts in adding to my knowledge base.

This is just a short post for now but Hello everyone. Keep up the research and may your day be blessed with findings.

Here's a picture of the first device that inspired me to research in the first place. It's more of a Hutchison device though it has an magnetic piezoelectric design matrix. Far more complex in fabrication than the SM device.

Have a blessed day!
ZRAD

[Grumpy]

Dr. Ray Brown's Crystal Sphere?

[zrad]

You got it!