Selfrunning cold electricity circuit from Dr.Stiffler

[Super]

*The statements that this circuit may be a manifestation of Cold Electricity may be in error. Continued testing of the circuit has not detected particular artifacts that should be observed in a 'Cold Electricity' circuit.

hmm, did he revoked his claims about CE ?

Ok, seems that all needed parts can be found in a common cheap radio,
wondering because it is nothing else than a Avramenko setup?!?

[hartiberlin]

Dr.Stiffler just updated his page with added parts list:

R1     1 ohm 1% 1/4W Carbon Composition     
R2    10K ohm 1/4W Carbon Film    
R3    50 ohm 1/4W Carbon Film    
      
   
C2    10pf 500V +/-5% Dipped Silver Mica    
      
D1    1N4148 100VRRM 0.5A (Switching)    
D2    1N4148 100VRRM 0.5A (Switching)    
D3    Blue LED 2.76V @ 20mA    
      
L1    2.2uH, Core Diameter 6.49mm Coil Width2.80mm Wire 0.58mm enamal coated    Picture below


L2    Transistor radio loop antenna coil and core, origin unknown, manufacture unknown most likely China.

59uH free of core +/- 15%
686uH on core +/- 15%

The wire is to multi-strand, size smaller than a human hair, inter-woven with Cambric or Cotton and bundle is corron covered.
   Picture below
   
      
B1,B2,B3,B4    

RF suppression ferrite beads

0.551" Length
0.140" Diameter
0.025" core dis.
   


I guess C1 is the 400 pF cap he spoke of in his first video.

[hartiberlin]

Here are the 2 pics of
L1
and
L2

[armagdn03]

who called it??? ONE WIRE TRANSMISION, no point in even looking at this, we already know about it. Tesla did it a while ago, its being done on the pyroclay thread, tesla coils use it. It DOES have OU implications if pulses are short and quick, but maybe 10 posts on teh same topic is good, more people will listen..

[hartiberlin]

Dr.Stiffler updated his page further.

Now the missing parts:

C1     0.01uf 1kv +/- 20% ceramic Z5U temperature coefficient


L3     9 turns of 0.018" enamal coated wire over the top and in the center of L2. L2 is covered with one layer of paper tape.
Care when winding, not to tight to damage L2.


M1     2N7000


Attached are the pictures of L3 wound over L2 on the ferrite core
and the circuit  board and the parts locations.