Selfrunning cold electricity circuit from Dr.Stiffler

[k4zep]

Hi Gang,

A couple videos that are all part of the story on how the SEC Flame might work........
(No I don't have a flame yet!)

http://www.youtube.com/watch?v=NoqC2AZadYM

http://www.youtube.com/watch?v=1AjtqGSjeL4

Ben

[ramset]

Ben   thanks wish I could hear it, Audio seems to be out  any one else have this prob ?
        Chet PS love the bubbles and current
       Also if you don't mind a 'still' of the schem [to fuzzy when I pause the vid

[IsaSIO]

Ben   thanks wish I could hear it, Audio seems to be out  any one else have this prob ?
        Chet PS love the bubbles and current
       Also if you don't mind a 'still' of the schem [to fuzzy when I pause the vid

All

the sound is clear for me on both vids. so Ben is this like the docs video of the three electrode cell? looks like you both are getting the same or close amount of gas? i tried stainless rods and a 2 farad car amp capacitor but did not get many bubbles. so you need carbon rods?

how do you charge those caps up so fast?

[k4zep]

Ben   thanks wish I could hear it, Audio seems to be out  any one else have this prob ?
        Chet PS love the bubbles and current
       Also if you don't mind a 'still' of the schem [to fuzzy when I pause the vid

Hi Chet,

Just listened to them a min ago.  Sound is OK on my computer.  I'll post the schematic HERE later tonight, leaving to go out to dinner, back about 11:00 EST and will try and get it up tonight.  Camera didn't focus quick enough on schematic.  It is a modification of the CRE single electrode device. 

Ben

[k4zep]

All

the sound is clear for me on both vids. so Ben is this like the docs video of the three electrode cell? looks like you both are getting the same or close amount of gas? i tried stainless rods and a 2 farad car amp capacitor but did not get many bubbles. so you need carbon rods?

how do you charge those caps up so fast?

Hi Gang,

Here is schematic of the relay driven CRE Tetrode Cell.  It charges and discharges via 2 different paths all the time for maximum output.  I do NOT know if it is correct but it sure makes lots of small bubbles.

You must use carbon rods.

1F/1V/1Sec and you are not totally discharging them........depends on current in cell also.  Be sure and use saturated distilled water and salt solution.

I HIGHLY recommend reading the CRE paper on Dr. Stiffler's site. MOST IMPORTANT!

Relay/s are a 12VDC relay driven by a square wave generator wired as in the pictorial.  Size of wire, contacts, etc.   Electrode placement, water, salt, etc. all add up.

Ben