Selfrunning cold electricity circuit from Dr.Stiffler

[AhuraMazda]

DrZLowe7,
Do you think you can get your supplier to give you the specification of the core material? There is a big issue about
Barium Ferrite properties and as we are trying to get to the bottom of things, it is important to know such facts.

Regards

AM

[DrZLowe7]

DrZLowe7,
Do you think you can get your supplier to give you the specification of the core material? There is a big issue about
Barium Ferrite properties and as we are trying to get to the bottom of things, it is important to know such facts.

Regards

AM

Please go back to the 16th posting page.
Stiffler says Barium not necessary.
So what the Doctor says then do.
Lets get off the Barium kick. If you are making this and it does not work it has nothing to do with Barium.
He says I told him they did. I never talked to guy and what you see advertised on my site has been there since I started selling them. If he says I told him that he is mistaken (I will not use the word lie).He can not put his Barium clam on me. I am not responsable for his claim.
Here is his quote:

Two things are no longer of significance until shown otherwise.

1) Effect caused by Ba content in the cores. This was built upon from another group where one of my circuits was shown. Because of frequencies an how the circuit responded it was a viable idea, for awhile. I have not run spectral analysis on any of the cores, I am taking  what was told me by the supplier that the cores were BaFe among other things.
Show me posting where he now changes his mind again?

I posted a while back. iron with zinc magnesium binder. No Barium especially as cheap as they are believe me tear a coil out of your radio will be better or same.

[dean_mcgowan]

DrZLowe7,

I am curious as to how many orders a week you would noramally recieve for these particular loop sticks and how
many orders you have recieved lately. Is business booming ?

Regards,

Dean

[hartiberlin]

Okay, I experimented now with the new coil-cores and I must definately say, that the amplification effect comes from the cores !
If you hit them with a pulse Via a coil, these cores just ring many cycles with their own resonance frequency.
So when you hit this resonance frequency or a harmonics below it, you get quite an a?plification by the selfringing oscillation of the cores. I will try to double check this now again with some other coils around the cores and post later some pics.
Please Dr. Lowe try to get the exact coilation of substances used on these cores. This is now very important to know how exactly these were built. Many thanks.

[linda933]

@Stefan

Are you saying that, using the coil only, when you pulse a single pulse from a signal generator and have a properly terminated resistance load on the other winding (in correct ratio to the impedance ratio of the transformer and nominal 50 ohm source load) that you get a ringing that lasts much longer?

I guess we will have to wait for your pictures but this would be remarkable only if the output is properly terminated and the output waveform and energy could be shown to exceed the single pulse input energy.  Lots of circuits and all reactive elements will exhibit ringing at some frequency when unterminated or improperly loaded.

Linda