Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Self Running Micro TPU, with closed loop.

Started by EMdevices, November 12, 2007, 11:49:58 PM

Previous topic - Next topic

0 Members and 18 Guests are viewing this topic.

Print
Go Down Pages 1 ... 47 48 49 50 51 ... 139
User actions

Bruce_TPU

#240
November 28, 2007, 12:03:44 AM
Hello All,

Well, I have run my last test for the night.  No joy from any of my earlier tests, BUT on this last test, I took the wire going from the anode of the LED to the primary bottom winding on the barium ferrite coil core, and moved it to the negative side of the capacitor.  I have one lead of the secondary from the barium ferrite coil, going to a 1N4007 diode and from there to the positive side of the 1000uf capacitor.

The LED lit MUCH more brightly per flash.  To the point that it hurt my eyes to look at it!   ;D

Total run time was still just over 37 minutes, though. 

A new round of tests tomorrow night. 

Holiday Cheers and good night,
Bruce
1.  Lindsay's Stack TPU Posted Picture.  All Wound CCW  Collectors three turns and HORIZONTAL, not vertical.

2.  3 Tube amps, sending three frequency's, each having two signals, one in-phase & one inverted 180 deg, opposing signals in each collector (via control wires). 

3.  Collector is Magnetic Loop Antenna, made of lamp chord wire, wound flat.  Inside loop is antenna, outside loop is for output.  First collector is tuned via tuned tank, to the fundamental.  Second collector is tuned tank to the second harmonic (component).  Third collector is tuned tank to the third harmonic (component)  Frequency is determined by taking the circumference frequency, reducing the size by .88 inches.  Divide this frequency by 1000, and you have your second harmonic.  Divide this by 2 and you have your fundamental.  Multiply that by 3 and you have your third harmonic component.  Tune the collectors to each of these.  Input the fundamental and two modulation frequencies, made to create replicas of the fundamental, second harmonic and the third.

4.  The three frequency's circulating in the collectors, both in phase and inverted, begin to create hundreds of thousands of created frequency's, via intermodulation, that subtract to the fundamental and its harmonics.  This is called "Catalyst".

5.  The three AC PURE sine signals, travel through the amplification stage, Nonlinear, producing the second harmonic and third.  (distortion)

6.  These signals then travel the control coils, are rectified by a full wave bridge, and then sent into the output outer loop as all positive pulsed DC.  This then becomes the output and "collects" the current.

P.S.  The Kicks are harmonic distortion with passive intermodulation.  Can't see it without a spectrum analyzer, normally unless trained to see it on a scope.

Pirate88179

#241
November 28, 2007, 01:35:10 AM
This topic is amazing.!!!!

Bill
See the Joule thief Circuit Diagrams, etc. topic here:
http://www.overunity.com/index.php?topic=6942.0;topicseen

tosky

#242
November 28, 2007, 03:28:03 AM
The newest torch design use super-cap. to replace the battery. So there is no special to use Capacitor to power your circuit. It is a good start to have a close loop circuit for O.U. research. Because it could prevent wrong result of getting energy from power supply or battery. Some guys waste long time to develop their devices, finally they realize the energy actually from power supply or battery. This close loop circuit is very good to evaluate where can get the energy, From vortex, ether, schuman resonance etc. I think it is wrong to increase the Capacitor to get the longer life time. It should be decrease the Capacitor, and tap to where possible energy source to extent the life time. This is more sensitive to find out the external energy. This circuit should be used as a (Energy- Probe). We don't need a Super Cap. Torch.

4549raymond

#243
November 28, 2007, 03:31:24 AM
Bill perhaps you could amplify a little and tell us why you think this is amazing. I think 37minutes with this setup is significant.If it can be tuned to the point that it does not run down without recharge then Bingo -truely amazing and in fact seriously significant. Until then I adore the approach of these dedicated experimenters

tosky

#244
November 28, 2007, 03:45:05 AM
Using the precharged energy to run the circuit is nothing new. More important is to use close loop circuit as an (Energy-Probe) to do research like a compass show you the way to O.U. Only a very little charging energy to startup. Then running forever.
Print
Go Up Pages 1 ... 47 48 49 50 51 ... 139
User actions