Muller Dynamo

[freenergy850]

@Scorch
Ya i had those thoughts too about the 2 driving circuits switched different ways.
Probably the driving circuit with hall sensor+ small extra magnets has weaker
force/acceleration (shorter pulse time) than the one with hall+ main rotor magnets.
Perhaps this is an important point to have these 2 different accelerations.

Romero uses two driving circuits, one in attraction (larger rotor magnets), and one in repulsion ( smaller outer magnets).
As far as changing the state of energy, i dont know that.

[xenomorphlabs]

Romero described this himself here: http://www.overunity.com/index.php?topic=3842.msg284851#msg284851

[chalamadad]

Bought these kind of bearings: http://www.amazon.com/4-Bolt-Flange-Bearings-UCF-201-08/dp/B0045JP60Q
Rotor doesn't spin at all. Not happy! 

What's the best way to connect the rotating shaft to the stator plates?

[freenergy850]

Bought these kind of bearings: http://www.amazon.com/4-Bolt-Flange-Bearings-UCF-201-08/dp/B0045JP60Q
Rotor doesn't spin at all. Not happy! 

What's the best way to connect the rotating shaft to the stator plates?

I would rip the seals out of those bearings and clean all the grease out with carb cleaner or something like that. Then just use a drop of good lubricant. Should spin better.

[chalamadad]

I would rip the seals out of those bearings and clean all the grease out with carb cleaner or something like that. Then just use a drop of good lubricant. Should spin better.

Thanks, I will try that. They are really stuffed with shit.