Muller Dynamo

[plengo]

Lovely to see that the "Delayed Lenz Law" is indeed very repeatable and relevant to Romero's motor.

Funny I mention that since the beginning and many think it is not relevant. I think now we should also think about the next piece of the puzzle (that at least I think it is), which is the Howard Johnson gate effect caused by the coil, biasing magnets (plural) where there will be a point when the right combination of the poles of magnetic fields on coils, and bias magnets will create a "tri-gate" where it will push the rotor even further.

Fausto.

[mariuscivic]

Hey Marius

Are you saying that if you dont have the light bulb on as a load first, then the shorting has bad effect, no speed up?

Is the bulb lighting as a load?

Have you tried adding more bulbs in parallel?  Maybe as you add more bulbs the speed will go up.

Mags

Hi Magluvin

What I trying to say is that with a load(12V light bulb) the rpm goes from 3000 to 1800.
In dead short the rpm goes from 3000 to 2600.
In dead short the rpm shouldn't decrease even more below 1800?
In theory, the dead short should produce highest lens force that will bring the rotor almost to a stop.For some reason (that I don't know) is not happening like that

[Poit]

Hi Magluvin

What I trying to say is that with a load(12V light bulb) the rpm goes from 3000 to 1800.
In dead short the rpm goes from 3000 to 2600.
In dead short the rpm shouldn't decrease even more below 1800?
In theory, the dead short should produce highest lens force that will bring the rotor almost to a stop.For some reason (that I don't know) is not happening like that

maybe theres a negative lenz law effect happening... see the thread about it http://www.overunity.com/index.php?topic=11350.msg299600#new

[T-1000]

maybe theres a negative lenz law effect happening... see the thread about it http://www.overunity.com/index.php?topic=11350.msg299600#new

Hi,

Plug oscilloscope to one of your driving/generator coils, see when and where BEMF occurs - adjust the magnets rotation speed while changing frequency to pass over that kick delay timeframe before it occurs and you have it...

Cheers!

[Poit]

Hi,

Plug oscilloscope to one of your driving/generator coils, see when and where BEMF occurs - adjust the magnets rotation speed while changing frequency to pass over that kick delay timeframe before it occurs and you have it...

Cheers!

huh? I'm not the one doing the experiments... (I wish lack of money)