Muller Dynamo

[T-1000]

It relates to loading a coil and seeing acceleration due to the position of the timing switch, not due to lenz avoidance.

Exactly - correct resonant frequency and correct phase...

[Magluvin]

Well, Ive been messing with this to get things right for a vid and I have to let my AA batts charge a bit.

Its funny, Im not getting speed up like I was last night. Im using all the same caps. Maybe the batteries being low is causing issues with where the rpms get to.  But I am getting the lockup at freq. Bigger cap lower freq.  And much higher voltages at freq.

Will make a vid in about half hour, the batts will have enough to show by then. We will see if the speed up comes back.  ;]

After the vid Im gunna have to play some more to get the speed up goin again.

Mags

[Magluvin]

Well  its gunna be about 120 min according to youtube. =[

http://www.youtube.com/watch?v=eNCF7uQzwzM

It wont show till fully uploaded and process.

It got cut a little short. My camera stopped reccording at just under 10 min, but the only thing missing is "ok Im finished"  ;]

Couldnt get the speedup.  Now Ill be up all night figuring it out.  But interesting stuff.

Mags

[DeepCut]

@ Magz,

Really, really interesting how the rotor 'wants' to stay there. Do you think the reason the magnets stop jumping is because, without the caps, the gen coil has a lot less parasitic capacitance ?


DC.

[mariuscivic]

Well  its gunna be about 120 min according to youtube. =[

http://www.youtube.com/watch?v=eNCF7uQzwzM

It wont show till fully uploaded and process.

It got cut a little short. My camera stopped reccording at just under 10 min, but the only thing missing is "ok Im finished"  ;]

Couldnt get the speedup.  Now Ill be up all night figuring it out.  But interesting stuff.

Mags

Hi Mags!

Nice video! I had the same problem too: one time worked, 5 min after didn't worked. Interesting fact showing the little magnet jumping around the coil while in resonance. I'm in love with your coils; i wish i would have something like that; all my wires are from old transformers witch takes me a lot of time  to reuse them.
Now i'm searching for someone or some company to do me some custom made coils but so far nothing.

I found something interesting in your video: the poles of your magnets are up and down,right?
If yes, than you should put your coils up or down for better results