Working Magnetic Motor on you tube??

[dean_mcgowan]

Have we yet had a one hundred percent accurate replication, including weights, magnet separation etc.  I think not.

And that would be because .... umm . you dont even have the correct spec ??

It would seem to me a waste of time replicating without the basic facts would it not ?

Cheers,

Dean

[vipond50]

Guy's
One adjustment to try is to slide the rotor magnets in the slot to the left or right of the center line, Of coarse this would have to be done with all magnets to keep the symmetry. This will give a few mm change in the rotor magnet radius. In my rotor I see approximately 3.5 mm change measuring form the inside edge of the slot to the inside edge of the Stator magnet.

Just something to keep in mind being the true radius is an unknown.

Regards
Bill

[g4macdad]

@ replicators

Look up the meaning of he word "conned".

He is not the messiah, he's just a very naughty boy !!!

Let it go guys !!!

Nice work all the same, but at some point you really have to take a long hard look at the facts.

Cheers,

Dean

I'll take this to mean you do not have a replication?

[Omnibus]

@vipond50,

Thanks. That's a very clever suggestion.

[Charlie_V]

I still think that the counter rotating stator magnet was not exactly 120 degrees in alignment with the others.  It looks like it's out of alignment by about 10 degrees to the right in the video.  Maybe it's just an optical illusion, but since nothing else is working, why don't you fellows try moving the counter rotating stator magnet closer to one of the other stators, maybe 10-20 degrees down the circle. 

I drew a quick picture to show you what I mean.  I have a feeling that if it's going to work, it will work with this type of arrangement.  Someone atleast try this, or if you have already tried it, what happened?

Thanks,
Charlie