Working Magnetic Motor on you tube??

[CLaNZeR]

@CLaNZeR,

I got to thinking today, while revising the opening review at PESWiki.

If I were you, seeing how you've had such a hard time getting the spec magnets to work, I'd go back to your interim set-up as shown at http://www.youtube.com/watch?v=vZPI5BwccsA and try to optimize that set-up.

I think that was a weight issue with the stator magnets even though they were weaker field as such. I have found by adding weight to the correct stators I am now seeing spikes when latching and also can get it too latch very easly.

Will drop back to those Stator magnets and do some tests though.

Cheers

Sean.

[Omnibus]

@CLaNZeR,

Are the stator magnets of your motor of the same strength as the rotor ones?

[CLaNZeR]

If you recall, in Al's video, after he sync's the one stator AGW, soon after, he stops, by hand the other two stators.  Okay, now, if you watch the two stopped stators, when Al removes his hands, they DO NOT start to respin on their own.

Hi Bruce

Cannot remember which Video now , but in one of them I demonstrate that the magnets loose interaction at certain RPM's and as the Rotor slows down again they start to interact. I think at about 800 RPM the AGW actually lost it as well.

This shows that AL's Rotor was definatley speeding up in his video for this to happen.
How it was speeding up is another question LOL

Cheers

Sean.

[Omnibus]

It doesn't seem that the latching (setting the unique stator to spin AGW). Something else is getting in the way, the improper field strength ratio, the improper form of the fields etc.

[CLaNZeR]

@CLaNZeR,

Are the stator magnets of your motor of the same strength as the rotor ones?

Craigy sent them to me, I think he sussed out what N ratiing they were in this thread somewhere.