Roll on the 20th June

[capthook]

edit -- nvm got it

rasta - what 2d design/print program did you decide on?

Anyone with suggestions? (cheap/free)

The software I use doesn't print to scale - so I have to resize the output and test print a few (or more) times to get the scale right..... 

[Fred Flintstone]

@bomber - Excellent post!

I'm afraid the truth is that Archer has nothing to show. Everyone that has posted on this thread that has *not* built something does not understand how difficult this task is. Buy some magnets. Use those tools that are collecting dust. Build a protoype. You will see that Archer has excellent skills. You will also see that closing the loop is very difficult. You will learn much more than you can imagine. I had a million ideas in my head that I thought would work. After the last few months of trying about 25 different ideas, I have a new perspective.

I'm just afraid that Archer could not get his wheel to run and has given up. I wish that were not the case because very few people have worked as hard as he has.

Freddy

[The Eskimo Quinn]

This is not for mankind, fuck mankind, this is for those that supported me without question and those that spent money on building machines.

I am going to load the pre run videos as i was putting it together and the first time it started to go around on its own more than 360 degrees. before you open your fucking mouth about any turing by hand when holding the wodd in place, which is show why, you will need to see the back of the wheel from the other side, so i will load a few pictures. there is no rear access to the axel it is one side exit from a fan.

You will also see the toughest fucking out wall in the world melted like butter it looks like there isnt one until you see it shown seperatly

Should be about an hour to compress and upload.

Now shut the fuck up, dont even see what all the noise is about, after all, nothing new here is there.

[therealrasta]

rasta - what 2d design/print program did you decide on?

Anyone with suggestions? (cheap/free)

The software I use doesn't print to scale - so I have to resize the output and test print a few (or more) times to get the scale right..... 

Does 3d too.. And Animation 

http://sketchup.google.com/

This is not for mankind, fuck mankind, this is for those that supported me without question and those that spent money on building machines.

I am going to load the pre run videos as i was putting it together and the first time it started to go around on its own more than 360 degrees. before you open your fucking mouth about any turing by hand when holding the wodd in place, which is show why, you will need to see the back of the wheel from the other side, so i will load a few pictures. there is no rear access to the axel it is one side exit from a fan.

You will also see the toughest fucking out wall in the world melted like butter it looks like there isnt one until you see it shown seperatly

Should be about an hour to compress and upload.

Now shut the fuck up, dont even see what all the noise is about, after all, nothing new here is there.

Awesome.. thx Archer for you dedication once again.   http://www.youtube.com/watch?v=a8Qf-0fgSJc

[The Eskimo Quinn]

up