Have you tried wrapping your generation vessel?

[exxcomm0n]

Hi all,

I finally got back to the HHO experiments that led me here and the editing (though very poor) of the latest videos so I could upload them to YouTube.

In this series of experiments I wrapped the generation vessel with both polarities before connecting to the electrodes and the behavior is not what I've experienced before.

Shoot! YouTube denied it because of length. Below is the new, better, working video link. (Thanks Bulbz!)

Take a look @ http://www.youtube.com/v/cMnQTsLIucQ , http://www.youtube.com/v/sEkLMc2EAr8, and any of the others in the related HHO_ver_VIII series and see if you can tell me why it happening.

Thanks!

[Bulbz]

What happened there ?. It states that the video has been removed.

[exxcomm0n]

Link updated above!

Sorry about that.

[Bulbz]

Any chance of drawing a schematic diagram ?.

[exxcomm0n]

Perhaps a little later this evening, but I'm busy painting a floor @ the moment.

It's really quite simple.
Look up plans or diagrams for a Tesla coil.
Wind 1 polarity as the primary (BIG wire or copper tubing and few winds).
Wind 1 polarity as the secondary (finer [magnet] wire and many winds).

Depending on where you put your electrode posts/connections wind the secondary from the farthest space (bottom for me) to the connection of the electrode and connect the wire to the electrode.
For the primary wind loosely around the outside (leave an air gap between as that's what I've tried to this point 3 or more loose winds and join to electrode connection.
Connect electricity to the loose ends at the bottom of the container.

I'll upload a schematic tonight.