URGENT! WATER AS FUEL DISCOVERY FOR EVERYONE TO SHARE

[vlindos]

@Chris31 ,
Hi, there,
I am at the same you are I can achieve visible explosion but the force is not enough for moving the piston.

Anybody here had the same issues? Had beat them ?

[Chris31]

@Chris31 ,
Hi, there,
I am at the same you are I can achieve visible explosion but the force is not enough for moving the piston.

Anybody here had the same issues? Had beat them ?

Hi

I finally have reached page 21 of this thread, still alot to read LOL.

Callanan at post 74 showed it > http://www.youtube.com/watch?v=-OTCqws_hsc

This is the stage I want to get to before replacing the relay with MOSFETs.

Im not sure if its a problem with my circuit, or maybe this just does not work unless its tried with compress air/water like inside the engine. If this is the case then Ill go ahead and get myself a mower/RC engine to play with 

[vlindos]

Hi

I finally have reached page 21 of this thread, still alot to read LOL.

Callanan at post 74 showed it > http://www.youtube.com/watch?v=-OTCqws_hsc

This is the stage I want to get to before replacing the relay with MOSFETs.

Im not sure if its a problem with my circuit, or maybe this just does not work unless its tried with compress air/water like inside the engine. If this is the case then Ill go ahead and get myself a mower/RC engine to play with 

Thanks for pointing me out that video. I was just staring at it too . He's been using 500uf/400v which is about 40J charge while I use capacitor at 23uf and bigger engine chamber. Hope the charge is the key. Tonight I am going to try again (with 2x capacitors).

[Chris31]

Thanks for pointing me out that video. I was just staring at it too . He's been using 500uf/400v which is about 40J charge while I use capacitor at 23uf and bigger engine chamber. Hope the charge is the key. Tonight I am going to try again (with 2x capacitors).

Im using 2x 1,000uF 200V so thats plenty.

Try putting a small piece of paper on top of the spark gap, it should atleast fly off if there is an explosion, are you getting that?
Thats what I expect to happen on my setup in open air, unless Im missing something. The polystyrene foam didnt even move LOL, just plenty of flash and bang.

[foxwhisper]

Yep, tried that Chris31,getting really good spark & noise but next to nil reaction, even tried a short cylinder over the plug blocking the end with paper & rubber band.Still no joy! think of looking at another concept as can't think of where I've gone wrong.