URGENT! WATER AS FUEL DISCOVERY FOR EVERYONE TO SHARE

[djzissis]

Hey Greg!!
Beautiful work!!

Can you post a schematic of the home-made inverter - oscillator circuit??

Are you using your VexUs circuit for the plasma, or Gotoluc's?? Please make it clear!!

Thanks a lot Greg!!
Awesome work again!!

Zissis

[happyvalley808]

Hi Greg,

I second that !!!!

Very nice !!

Thanks for sharing!!


Regards,

HV

[gmeast]

Hey Greg!!
Beautiful work!!

Can you post a schematic of the home-made inverter - oscillator circuit??

Are you using your VexUs circuit for the plasma, or Gotoluc's?? Please make it clear!!

Thanks a lot Greg!!
Awesome work again!!

Zissis

Yes,  I will post the circuit ... got it off the internet ... I am using VexUs ... I am going to exhaust the attempts at a piggyback arrangement because it has more potential for more people.

Greg

[revizal]

Great work Revizal,
you could do some torque/poweroutput measurements later on to see how more efficient it runs.

Unfortunately, I do not have the tools..sorry.

[gmeast]

Hi all,

... finished the oscillator, mounted the xformer, mounted the fan, mounted the board on the VW engine compartment back plane.

Here's a pic of the board and a pic of the waveform. It is about 300VAC P-P @ 70 hz. and 247 VDC at the storage Cap.

The oscillator-part is from the transformer and to the right. The voltage multiplier is the two diodes and two caps at the lower left and then there's the fan (1-1/2 square).

It sags a little more than I like at high speed (2400 RPM, 4 cycles per rev = 160 cps). It droops to about 165 VDC at that speed but that's plenty to bring the plasma event.

Peace,

Greg