Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Buoyancy device and wheel and bubbles

Started by AB Hammer, October 11, 2008, 10:15:25 AM

Previous topic - Next topic

0 Members and 3 Guests are viewing this topic.

Print
Go Down Pages 1 ... 5 6 7 8 9 ... 17
User actions

grayone

#30
October 20, 2008, 09:45:42 PM
AB Hammer
I am looking forward how you solve the bubble making that is needed.

capthook

#31
November 08, 2008, 05:22:22 AM
At first glance my thought is:

The "float" is hollow and isn't really very "floaty" but closer to neutral. 
The bubbles go into the hollow of the float to give additional lift.
Once the float enters the water again - it is filled with water - making it heavy and sinks.

So lift by air bubbles filling hollow float.
Drop by hollow float filling with water.

?

P.S. The thought of using heat that others recommended might be even better.  A small heater at the bottom with a small nozzel sprays the heated water into the float cavity causing lift.....(because hot water rises)
At least this would overcome the water-pressure problem of getting bubbles to the bottom.

AB Hammer

#32
November 08, 2008, 08:47:47 AM
capthook

The floats are not hollow. The bubbles reduce the density of the water and enough bubbles will sink any buoyancy float allowing the buoyant side to lift the floats not in the bubble tube. The trick is to get enough bubbles to do the job from the lift from the buoyant side.
With out a dream, there can be no vision.

Alan

capthook

#33
November 08, 2008, 05:14:57 PM
Yes - I realize they are not hollow.  I was just giving my take on how you might change/improve the design.

AB Hammer

#34
November 08, 2008, 08:15:02 PM
Quote from: capthook on November 08, 2008, 05:14:57 PM
Yes - I realize they are not hollow.  I was just giving my take on how you might change/improve the design.

capthook

Thanks for the suggestions, for in this game you have to consider each and any possibility as well as the negatives with some ideas. For instance the heat is not practicable for this project for it has to produce on its own. The heat will need another source for energy to run it, which would defeat the purpose. Here is what has to happen. The bubbles needs to take up 40+percent of the water in the tube. This will allow the weighted floats to go downward into the water with very little buoyancy when the non bubbled side has full buoyancy which should give the force needed to perpetuate. At least that is the plan for the first build. Any additions and changes will be taken after that.
With out a dream, there can be no vision.

Alan
Print
Go Up Pages 1 ... 5 6 7 8 9 ... 17
User actions