Joule Thief

[jeanna]

xee2,
You also have made a tank circuit at the base resistor using a 200uF cap.
Also your drawing indicates 2 batteries??

jeanna

[Pirate88179]

So with the spikes it is also capturing current/F, right?

Xee2 would know better but I think that the Farads are made up of both volts and amps.  I believe this to be true or I could not have run my Bedini motor from my electrodes/supercap set-up.  The Bedini will not, to my understanding, run on volts alone.

Bill

[xee2]

@ jeanna

xee2,
You also have made a tank circuit at the base resistor using a 200uF cap.
Also your drawing indicates 2 batteries??

jeanna

I do not know if it is a "tank" circuit. I think those may be LC circuits. The two batteries were because I think Bill is getting about 2.5 volts out of his EB.

[xee2]

So with the spikes it is also capturing current/F, right?

I am not sure I understand question. Capacitors stores charge. The spikes can push extra charges into the capacitor because they are at higher voltage and thus can push harder.

[innovation_station]

how my bedini chargers work is just that ...  i push the power engery through my coil ... then to the recovery cap so it is 12 v on the output cap ...    then i turn off the coil .... the fly back also compounds in the recovery cap thuss rasiging the voltage and giveing the push ...  i slow it down from the cap with a diode ... to the recharge battery ...  the  more i get for push in my cap the faster the tpu will runn ..  as im elelimiting the DRAG .. OF THE BACK EMF ...

SO NOW it will speed up to find ballance insted of slowing down ...


verry much the way thanes motor works EXCEPT  he has given the colapse a magnetic return path to the driveing induction motor thus aiding the driveing magnetic feilds and accelerating insted of slowing down ...  he does this with a shorted coil ...  the generator induces electricty in the shorted coil .. after it is past the magnet that induced it.... it then  colpases and flows through the flux feild return path to the induction core ..

but who knows ... 

ist!

wow i got my 30 hp motor stripped ...  i now have a VERRY NICE ROTATION GEN TRANSFORMER CORE ...

WITH 36 SLOTS ...    i think my pulse motor will rock the block!!    i plan on turning 4 altonators  at minmun 40 amp dc each ...  it is in the mass of the pulse motor and the gearing reduction to increase torque then it is a pully thing ...  my goal is for the pulse motor NOT TO SEE THE WORK IT IS DOING... ..  I WILL  acomplish this through the gearing and mass .. 

im setting up A BIG DEMO UNIT ON A FARM NEAR THE MOST POPULAR BEACH IN CANADA.. 

if your looking for me ill be at the beach!

W