Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Electromechanical Inverter

Started by z.monkey, February 05, 2009, 05:55:55 AM

Previous topic - Next topic

0 Members and 5 Guests are viewing this topic.

BEP

Hmmm...

A filament transformer, no center tap.
A 2PDT 12VDC relay.

???

I always enjoy your project postings but I don't see how this will work, yet  :)

z.monkey

Look at the configuration of the relay.  It's a Inverter...

Here's a better picture...
Goodwill to All, for All is One!

BEP

Quote from: z.monkey on February 05, 2009, 06:25:29 AM
Look at the configuration of the relay.  It is an inverter...

Here's a better picture...

AHA! A signal generator! First time I've seen a separate signal generator used in a power inverter. It might take a brute of a signal generator to drive that relay.

Take care.... If the relay isn't always changing states it will fry and probably burn the transformer too  :o

z.monkey

Howdy,

The signal generator is separate because I want to use my PIC 18F252 'sperimenter board for testing.  It has a preamplified IRFZ44 to drive the relay (no worries).  Later when I get the buggers worked out I'll replace it with a set frequency signal source, but I want to play with it a whole lot first.

Notice there is a separate switch for the power going to the relay switches.  This is because it takes to PIC a couple seconds to boot.  So first turn on the signal source and then turn on the inverter power.  Using the PIC as a timer allows me to programmatically alter to frequency of the relay, and I have a range of ~30 Hertz to ~500 Hertz to play with (frequencies that the iron transformer will respond to).  So I could program a sequence of frequencies, say simple music, and have my inverter entertain me...

OK, Mo Later...
Goodwill to All, for All is One!