ENERGY AMPLIFICATION

[Magluvin]

Dont stop there Googs. Double up and tripple up them repeat posts.

http://www.overunity.com/6763/energy-amplification/msg389687/#msg389687

Sometimes you just have to beat it in to us, ya know.  What do ya got, 10, 50 more pages to make your point? From what Ive read from your posts so far, I think I get your point.  Anything more I should be aware of, or is that it?    There are many pages of others saying just as you have, right here in this thread already, in case you havnt read it through. Just letting you know, and I only need to say it once. Right?

You mentioned Romero as being a fraud. Can you prove that statement? 

Mags

[Magluvin]

Mags, that is interesting.

I worked on that exact concept of the single turn at the top of a "Tower" coil.  I went a slightly different route and I'll give you my results.  I learned (From reading a paper.) that the tesla tower, being a resonant device, has a tremendous voltage gain.  It is also a non-linear component, as in, the current IS NOT linear.  There is a much ignored possibility there, as I have posted before, that instead of tuning the peak at the top of the coil, tune it for the center.  The top will then be at 0V, which, if done correctly, could allow this component to be used in Both ways.  (Linear and Non-linear.)

A single turn could then pick up a LOT more power than what it takes to setup the standing wave, but that is where I ran into trouble and stopped playing.  (Got bored as well...)  The tuning is very touchy.  I spent a couple days just to be able to "See" the tuning on a scope by using a one wire pickup, but I was shocked to see that my body could de-tune the thing from more than 5 feet away.  As I am not into decoding Smith charts as they relate to this type of tuning, and setting up and walking away was not an option, I had to give up at that point.

The concept is sound, but it proved to be more trouble that I was willing to deal with.

I wish you all the luck.  If you could lock down the tuning for a specific load....   I'd love to see it.

Hey Loner

You always have some good input.    I was thinking that my TC wasnt really tuned. I built it on a wim in a couple hours. Was a good experience with what it was.

But I have some new ideas to expand on that.

Mags

[forest]

Loner, thanks. I believe it is all about radio waves.I believe in simple nature thus EMF is radio wave, but not that kind we are taught in school. Remember , there are various waves like in case of light ; you could have white warm light and a sharp polarised laser beam.

[DilJalaay]

Hello All,


I got some three terminals caps from scrap.


I fond a strange thing with them, which i want to share with you.


I charged the cap(24-VDC and remove the power supply) via A and B terminals.


Then i check with my Fluke17B voltmeter, voltage across;


A,B= 24VDC.


B,C=2VDC


A,C = 18VDC which stay at 18VDC although i short them and check again it stay again at 18VDC, but found that no current while discharging  AC.


I hope somebody better explain this cap behavior.


Thanks and regards,


D.J

[Lakes]

Never seen a three terminal cap before.

Guessing that it's two in series?