Meyers Type WFC - the Key to Efficiency

[dankie]

Yeah well it doesnt work , all that stuff they tell about a bifilar wound like that configuration just isnt true , or I cant make it work .

I believe it is an over simplification .

The question I ask myself now is what does Stan's brother use .

We know his company uses a special method but what ?

Also , why did he change his name to Stephen Barrie Chambers ?

He applied for that Hydroxyl refilling station but it was never accepted . There is only a patent app .

Then he moved to Canada and changed his name , and is now only doing water treatment .

[CrazyEwok]

Welcome to the seemless neverending strugle to copy Mr Meyers THECELL!!! Good to have you on board!!! Nice work on making the 2 tubes the same frequency! Just a question on that, why are you making the tubes resonate and not the water? Also if you read into some of the older posts you'll understand Dankie's less than enthusiastic approach to this concept... Whats your team working on now??? i can't keep up you guys change projects so often...
As for your questions i suggest you look into it as each cell and infact each set of variables will be different (so will the extent of the reasearch and how far you push your variables). Can i ask which principals are you basing your cell ideas on? Since your attempting something that hasn't been widely replicated yet i assume you have an idea or theory where someone has gone wrong in getting this idea to work. Good Luck, don't take anything anyone says on here for granted or gospel!!!
-Ewok

[CrazyEwok]

Yeah well it doesnt work , all that stuff they tell about a bifilar wound like that configuration just isnt true , or I cant make it work .

I believe it is an over simplification .

The question I ask myself now is what does Stan's brother use .

We know his company uses a special method but what ?

Also , why did he change his name to Stephen Barrie Chambers ?

He applied for that Hydroxyl refilling station but it was never accepted . There is only a patent app .

Then he moved to Canada and changed his name , and is now only doing water treatment .

Dankie,
If I believed my brother was asassinated and then discredited to a point where the mention of any connection to him with this tech could be a draw back, because of a technology that i knew how to build... i would move countries and change my name too... Then look at a way to incorporate the tech into an area that is a little more low key... then implement it slowly as a BREAKTHROUGH in an alternate use for an already established and standardized technology...

[HeairBear]

OK, maybe try this... Use your Lawton PWM and connect it to a coil, any coil, and 12v lamp. You may have to try a few different size coils for greater visible affect. Look for when the light is the brightest and when it's the dimmest or completely out. Measure the voltage and amperage at these points. Take note of the frequencies also. These points of brightness are self resonant frequencies of the coil, any coil... Yes, the coil in the diagram is non-inductive but there is still parasitic and distributed inductance in the circuit as a whole.

[TheCell]

Ok the resonance of a LC circuit .
Ravi's cell wires got hot , even though the amperage into his circuit was very low. Resonance of a serial LC circuit .
There the other thing with rosemary ainslie circuit ; this has nothing to do with resonance.
Ravi was getting the highest efficiency with the lowest current.
It seems the duty cycle was very short. The amount of power to get from the outside is limited. All further increases of the duty cycle drains only power from the power supply.

I think Xogen uses resonance in combination with standing waves.
The forces at the plates are zero while the force in the middle between the plates reaches a maximum allowing fractioning of water into HHO with comparable low power.
The same effect takes place in the pete davy heater.

Resonance can do. I got to do some experimenting work.