The Master Of Magnetics "Steven Mark"

[supersam]

giantkiller,
let's say you take power out at the nine points like a rodin torus.  what happens?  nothing!!! it was ready to be harvested.

lol
sam

[supersam]

marcos,

remember you only used a little of the power and transposed it; or only the control wires are wound vertically.  which comes back to the question.  HOW  are the control wires wound?  how are the collectors wound?

their length must be CALCULABLE!!!!

think first to the "NATURE OF THE UNIVERSE!!!!   1.618 IN OUR PERSPECTIVE.  PHI!!!

lol
sam

[mrd10]

Hi All,

Something just came to me, while thinking about what Steven mentioned, that one kick isnt enough but when you combine many kicks, thats where you see some amazing things, like Dave's scope output I think he has hit the nail on the head.

This is what I'm thinking, even the days when i built a preamp, the preamp had to have a ramp up delay as it would damage the speakers when you first turned it on, as you would get a loud thump. I'm thinking along the lines of what Steven has mentioned that theres an interaction with the earths magnetic field and electrons in a wire.

I'm looking at this real simple like:- So if we were to have 10 people flicking on and off switches going into say 10 transformers, and these transformers were connected in parallel, I reckon the kicks collected would be substantial in nature.
As Steve mentioned when you first turn on a cct theres a kick.

Cheers, all and keep up the good work

Fantastic

Mrd   

[giantkiller]

I think I stumbled...

My previous posts have mentioned some of these things before, but all of you have done the experiements to prove!
Thanks. No, I am not trying to grab glory. I just couldn't get my controller in time. But that is ok. The part I saw myself in was appearing past the initial attempts. I, like Marco, would like to avoid winding another coil. But with everybodies efforts, the next coils would less incorrect than way off base. Kapeesh?

@Marcos....
Your coil partially worked because of a previous post. I mentioned that the bypass diodes in the MOSfet might be the fault. But how does one increase the power out of bipolars other than the MOSfets without dire consequences?

And the cu de gras is my coil is speaker wire! I am already stranded! I kinda fell into that.

So the question that still digs at me is the clocking control for the 'close in time' freqs. I have two for the bigger coil scenario, but on a small diam coil. I could have the best or worst of both worlds. Small diam coil with 16 g stranded wire, with 3 layer cross wound of 88 turns at 4 segment times 2. I am thinking power drivers.
My skeptism at this config is that my coil wiring doesn't match up with the diam to maximise the freak wave/harmonic at the desired distance for the necessary wavelength. And I am driving with MOSfets.

I wait for replies.

Oh, and another thing...

All is good! Damn good!
So what can I expect to see from further progress? I myself am finishing putting together the controller. I plan to keep the sloppy 556 clocks in the works. I start from there. Ooh, ya know I think supersam or gnostic mentioned crystals before. Eh? Crystal controlled timers would the cats meow.
I gotta quit postin and get back the boards.

[supersam]

giantkiller,

you you might want to take a " a look at the rodin coils" before you jump the 88 is not a possibility, unless it is something different.  but if you are looking for high tech?  i just didn't want you to dive into something unknown without at least realising it.  i hope for the best.  watch out there could be alot of power behind door #1!!!!!!

lol
sam