The Master Of Magnetics "Steven Mark"

[otto]

Helo,

@Dave

google "USPTO" > patents > search> patent number search> 390721

it works. When you see the drawings I think you will start thinking about this business with our TPUs because I now know how to connect all the wires that are going out of my TPU.
I can only say that the signals are wonderfull!!

Otto

[mrd10]

Helo,

@Dave

google "USPTO" > patents > search> patent number search> 390721

it works. When you see the drawings I think you will start thinking about this business with our TPUs because I now know how to connect all the wires that are going out of my TPU.
I can only say that the signals are wonderfull!!

Otto

Hi Otto,

Do you have a set of magnets? can you place them in different postions to see if the signal gets bigger , and if current draw gets smaller, also see if the roation of the compass goes faster.

@Dave were you responding to me about the coils? I'm new to this different types of coils, i'll have to check on net what the different types are. Anyway i'll be back later on to check on the posts.

Cheers,

Dom

[hartiberlin]

Helo,

@Dave

google "USPTO" > patents > search> patent number search> 390721

it works. When you see the drawings I think you will start thinking about this business with our TPUs because I now know how to connect all the wires that are going out of my TPU.
I can only say that the signals are wonderfull!!

Otto

Otto,
do you mean this patent ?

http://v3.espacenet.com/textdraw?DB=EPODOC&IDX=US390721&F=0&QPN=US390721

Regards, Stefan.

[otto]

Hello,

@mrd10

yes, I tried with magnets but so far no results but I tried something else.
I like the "Good night story" very, very much. For myself the key for the operation of the TPU is in this story. You only have to reed "between the lines".
A few days ago I tried to make my setup of the TPU like in this story and I get such results that I never expected. My output voltage is "something" and I tried to measure the frequency but i couldnt. Then i realized it is DC with a lot of everything like SM said. Of course I havent lit any light bulb. Not yet!

Otto

[otto]

@hartiberlin

yes, look only at the exiter coil and the transformer coil.
The exiter coil loosk like my control coil and this is ok. What I will try is to feed the signal from this transformer coil (my 1mm coil wrapped all over all coils) to my collector coils. I see this transformer coils as outputs. I know I will see a little spectacl.

@Dave

I did not measure anything. In this moment the coils are not in any angle. Of course I will try that. Weekend is coming and I have a lot to do with my TPU.

While I was connecting the wires like in this patent I saw my magnetic needle begins slowly to rotate. There was nothing else connected to the TPU!!

Otto