The Master Of Magnetics "Steven Mark"

[Thaelin]

Arose today and still showed 358 pages of messages to catch up to. When I opened the next page, down to 237 pages I went, whats going on here???

I just lost out on 100 pages of messages.

sugra

[allcanadian]

I didn't know you could do that-remove all your posts, that seems kind of rude. I think im outta here as well though, multiple frequencies,resonance ect... it's no easy matter. I think there are easier ways to do this OU, and your average person would have a hard time building such a machine even with perfect instructions.so best of luck

[Thaelin]

And then there was 234 five minutes later. Guess we got too close for sure.

sugra

[lynx2000nl]

To all the smart guys here,
and to all you ladies who DON'T want to think any further than their frontdoors.

I know some people directly go of wining that the SM device had no solid core(iron)
I know everyone shouts, it's about the kick's !!!

Well, everyone is wright. It IS about the kicks. It is about the kick, that a stabelising magnetic field gives as induction to a coil.

http://i125.photobucket.com/albums/p51/renerator/freeenergy.jpg
Looking at the renerator again, i noticed the following.
The energy collected to use and to fire up the 2nd circuit is the energy produced by the KICK of the magnetic field stabelising after the actuator pulse was given. As we all know, a magnet distributes his field lightnig fast to the surrounding it is. So after the actuator pulse was given, the magnetic field instantaniously returns, giving us the KICK !

Then, i thought about the people shouting, there is no core, there is no core.
Well, maybe that indeed is an option.

Make primary windings like in the renerator, but wind the secundary windings over the primary windings. Much like most of all you people already have done. When putting a magnet in the vincinity of the windings, it will influence them. Activating the primary coils disrupts the field. Which then rearanges. This rearanging KICK is collected in the output/secondary coils.

But ... If you wire this all up, without diodes, like in the renerator, you will (kill) the input kick in the primary coil. So it is very important to use only the regenerating magnetic field as your power source and NOT your self inducted magnetic field.

With diodes placed in your circuits like in the renerator, you will.
create a magnetic field which disrupts the permanent field. Then, when you give no power to your system, you can harnass the tremendous power of the kick that the permanent magnet field gives when restoring it's own field.

It is as simple as it can be. just give it a try.

[mrd10]

Ok I don't know whats going on, has some people left and taken there posts with them?

What is unknown should be discovered, maybe we walk straight past it everyday, without giving it a second thought.

There are briliant people who pick up on this and try for a number of years to make it to there advantage, and when that happens,....WOW  WEEEEE    Fantastico.

Now all we have to do is LISTEN to and take note of these special peoples accomplishments, rather than say how can that be, and all that crap.

Now from SM:-

Trial and error is the best way to make new discoveries. If we rely completely on what we are told by scientists and engineers we will never make any relevant discoveries because we are told not to try, that they are impossible.

END

That is a good advice

Discovery,

Again i'll post what I compiled with Lindsay and Steven Marks, save it and read it LISTEN.

Dom