Are Tommey Reed´s pulse motor circuits overunity ?

[amigo]

How I made my TR Pulse Motor 001.mp4

http://www.zshare.net/download/58779608d3d9ec96/

[amigo]

double post - delete

[powercat]

OK he's back and he's on Yhoo video

http://video.yahoo.com/people/5889505

cat

[powercat]

This one was the last one I saw before he took them down
http://video.yahoo.com/watch/4878399/13002877

this one is new and shows his DC power station
http://video.yahoo.com/watch/4878251/13002401

and finally this one
http://video.yahoo.com/watch/4876058/12998172

only thrree available at Yahoo video   videos were posted over 30 hours ago
I am now in the process of backing them up   at the moment my download speed is very low
so I hope I'm not the only one doing this

cat

Tommey's back on YouTube. New name/EnergyTechnologyNow
http://www.youtube.com/user/EnergyTechnologyNow

[Goat]

I just checked the last video and his calculations of Watts are way off (might be somewhat dyslexic) as he mentioned the following:

For the input of 1.5 V x .155 A = He says  205 Watts but it should be 0.2325 Watts and for the output of 12.75 V x .045 A =  He says 573 Watts but it should be 0.57375 Watts.

There's also the fact that all this is being measured as straight DC but it's pulsating DC so the figures could be way off depending on the meters being used, it's odd that in one of his 25 video's he was using an Oscilloscope but not when reading the input/output of this setup (too bad because it probably would've helped).

At any rate, it's an interesting setup but I can see that the TR1 schematic that I posted isn't what he is using because of the PWM but it's a start

Regards,
Paul