Are Tommey Reed´s pulse motor circuits overunity ?

[poynt99]

It usually comes down to this:

1) Like clockwork, someone new discovers that using inductive kickback, they can charge a capacitor or drive a load to a higher voltage than the applied input voltage.

2) They have unknowingly discovered the well-known world of switched-mode power supplies and DC-DC converters!

3) The knowledge of proper measurements is lacking along with the appropriate instruments for making these measurements.

4) The 'inventor' shuts down and leaves due to the advice given by those that have previously tried this themselves and confirmed the reality of the situation.

5) Simple concepts are overlooked or just not investigated, and this leads to false notions about what is happening in the circuit and with the measurements.

6) Unfortunately, folks become annoyed and defensive rather than sincerely contemplating the possibility that they are perhaps mistaken.

And so unfortunately the cycle continues...

.99

[jas_bir77]

@all
if anyone has backed up tommey reeds videos can you share them whith everyone .
thanks

[Tommey Reed]

I am reloading them on youtube

[jas_bir77]

I am reloading them on youtube

thanks a lot man
will u b loading all of them.
when can we expect to see them on you tube.

[hartiberlin]

It usually comes down to this:

1) Like clockwork, someone new discovers that using inductive kickback, they can charge a capacitor or drive a load to a higher voltage than the applied input voltage.

2) They have unknowingly discovered the well-known world of switched-mode power supplies and DC-DC converters!

3) The knowledge of proper measurements is lacking along with the appropriate instruments for making these measurements.

4) The 'inventor' shuts down and leaves due to the advice given by those that have previously tried this themselves and confirmed the reality of the situation.

5) Simple concepts are overlooked or just not investigated, and this leads to false notions about what is happening in the circuit and with the measurements.

6) Unfortunately, folks become annoyed and defensive rather than sincerely contemplating the possibility that they are perhaps mistaken.

And so unfortunately the cycle continues...

.99

Well, yes, in the last video with some real load like the hotgun dryer,

Tommey is now using the BackEMF to run directly the heatgun.

It seems to have just
only  66 % efficiency
from the test, where he used 50 Volts on the cap bank at the end of the movie.
So no overunity.
Would be interesting to see, how the efficiency will be, if he will drive with the BackEMF the motor/generator combination and hook the heatgun to the generator output.

http://www.youtube.com/watch?v=zqtRjudNTSg

Well, some people just point out over here the errors some inventors make
and some of their measurement errors.
This is a free speech forum about these topics
and when inventors make measurement errors,
they have to be pointed out.

So this is also a way to help the inventor to make
his circuits better.

It has nothing to do with pushing the inventors away from this forum.

Inventors should have more self confidence and should defend themself better
when they think they are right and also should admit, that they have done
errors, when somebody else points them out and the inventor will see the error then
by himself.
We all make errors.
So there is no problem to accept this.
But it has to be pointed out and agreed on it, so we
know which measurements are right or wrong.
Otherwise we will never make any progress.

Just think about this.

Regards. Stefan.