The ever elusive magnetic motor

[ramset]

Bill
yes I have seen this
http://keelynet.com/gravity/bedham1.htm

Not what I saw !!

OK
I see this is looking alot harder than it is.
Mental picture,
take a frisby lay it on a piece of 1/4 inch plywood
trace the outline of the frisby  adding 3/8 of an inch all the way around
cut out the hole put the frisby back in the hole you should have 3/8 gap all the way around
Take a roll of pennies put them all around the outside edge of the frisby, flat on the top outside edge then put them all around the hole[flat on the top edge closest to the frisby]replace pennies with mags  put them allnorth on the frisby allsouth in the hole
YOU HAVE SUSPENTION IN ATTRACTION[NOT REPULSION}
Of course the frisbee should be wood [so you can draw laytout lines from one side to the other so you know your mags are balanced]and the mags I saw were1/2 inch round by 1/2 inch tall cylinders

just for clarity you could flip this disc upside down and sideways and not remove the disc from the hole .
He said it would hold the weight of a person!![right side up or upside down]

I suppose I'll replicate and share
Chet
PS
I suppose I'm just curious if this closed loop[trapped in attraction] hovering field will have properties that allow it to be spun with out gates/cogging?
PPS
is this the road to magnets shielding themselves ?[something I was told was possible]

Ply- N MAG 3/8 spaceS Mag   d    i    s   k  S mag 3/8   N mag
        ====              ====                     ====          ====
        ====               ====                     ====          ====
========               ====================          ==============
PLY N MAG                S MAG    Disk         S MAG          N MAG  PLYwood
                               THIS DISC FLOATS IN
                                 ATTRACTION

[billmehess]

If the top disk is spun it will rotate very unstable and it will stop quickly. There is no cog or gate in the configuration. I can see where you are trying to go with this but if you introduce an external stator assembly the standard coging issue will rear it's ugly head.

[ramset]

BILL
Its not a top disc
All mags were on the same plane  ===  === FLAT
Chet

[billmehess]

I understand , but again I suspect it's a Hammel spinner principal.

[0c]

BILL
Its not a top disc
All mags were on the same plane  ===  === FLAT
Chet

Something is missing in your description. Next time you go for a visit, find out what. Better yet, take your camera and post some photos. Is there a patent description?

Thanx