Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[baroutologos]

The impedance and frequencies have answer to that. Same as using few turns coil in step-up transformer and driving circuit for it.

P.S> We are not dedicated 24/7 to this forum so be patient for getting answers..

Hello T-1000, sorry for my rush, but i kept answering that question from the very beggining.
..
Anyway i am not sure i quite follow you. Of course the winding's impedance will choke currents of high frequencies and stopping them from flowing to the FGs. (revised)

In other words, the FG starts supplying some current A at say10 volts, (not even close those speculated 0.25amps at 200 Khz or so because FG impedance 600ohms as Weslay said in the video + windings impedance atthose frequencies.) I can accept that a voltage rise of 0.3-1Kv range at those 1,1 Mhz or even 260 Khz frequencies can (?) cause no harm to the FG.

What about the 50 hz frequency? In the end, it is the 50 hz volatge frequency that climbs up to KV range (without any load attached). Impedances at those 50 hz are not worthy to be mentioned at constraining currents at those 50turns primary or 15turns from inrushing the signal generators.

This is critical to be answered in my view.
Thanks

[Shokac]

Think in 3D

[forest]

Think in 3D

Oh, no Shokac.. Don't spoil so inte - resting Wesley thread   

[Shokac]

Oh, no Shokac.. Don't spoil so inte - resting Wesley thread 

Congratulations my friend Wesley but, after spent lot of money, I think it is not looking in the right direction.

[verpies]

Its a "bit" confusing and complicated to the average tinkerer in here,

Yes it is hard to understand.
Those static captions describing what windings are connected to what, would help a lot.