FM Concepts posts working video 4/7/2009

[CLaNZeR]

Rather than repeating it and details of replication, check out thread

http://www.overunity.org.uk/showthread.php?t=378

Cheers

Sean.

[Goat]

@ CLaNZeR

Nice video, very compelling

I noticed though that the magnets are specially aligned, is that covered in the inventors plans?

If you notice in the photos of the top and bottom you can see how the magnets are arranged.

Regards,
Paul

[onthecuttingedge2005]

I enhanced the Gamma a bit on one of the pics that was kind of dark.

you can see the hot glue that was used to orient the magnets.

[onthecuttingedge2005]

I really think he should of made the Stator and assembly from clear Acrylic.

if it requires Slick/oiled Teflon then maybe a Teflon sleeve with Teflon oil would suffice so that everyone could see into the device and solve some doubts of others.

it sure would be nice to be able to tell the Physics department they were wrong about such a device. but I am not counting the chicks just yet until hatched at least.

but it is a nice show so far.

it looks like he used one size of magnet and pushed them into holes to orient their length on the sides and then hot glued them into place.

Jerry

[lumen]

I think we need better video. At this point it could be anything.
It sure looks like it works much better on exact locations on that table, or even best right over the transformer?

Hmmmm...... , I'll wait on this one for the better video.