Bedini SSG - self sustaining

[Magluvin]

Ok guys, Just uploaded a vid with a funtional 2nd stage running off of the 1st stage bemf, and charging an old 12v 7ah bat off of the 2nd stage bemf.
http://www.youtube.com/watch?v=nXxvAQ_mdUk

I am letting the battery charge to see where it comes up to.
I am very happy with this setup. =]

Magluvin

[plengo]

@Magluvin

great work my friend. It is becoming more and more like the claims of Dr. Adam. I am bluntly impressed with your work.

I finally got my new reed switches just like yours. Now I have to order the coils. Slowly but surely I will replicate what you are doing too!

Keep it coming, please.

Fausto.

[Magluvin]

Thanks Plengo
I made that transformer on the whim. making another tonight, but a bit smaller.
Did you check out those audio coils at Parts express?  Awsome selection.

I have read that an air core transformer can amplify the power, not just current or voltage. The one in the vid is going off of an idea from tesla, but I think it is more for high voltage and freq, so Im going smaller n tighter.
The vid before that one, with the second stage active on the rotor, the reeds were switching out of phase for sure. And it worked. The battery went up to 8v but settled back to above 4v. She is a goner. I am very exited about the amount of bemf "power" I am getting from these coils. In the beginning, after seeing what everyone else was using, I assumed more turns/finer wire, but now I feel differently.

mags

[guruji]

Hi guys is there a way to charge 12v batteries with bedini motor through caps? cause I tried bedini motor to charge batteries but it seems that it was ghost charge after a day they return as they were.
Any help please?
Thanks

[Magluvin]

Hey Guruji
I have not gone full bedini yet, as in using one battery to run the circuit and rotor, to charge, or say exchange charge to another battery. I have been trying to get beyond batteries, hopefully, someday. My aim is to try and get the most out of back emf as compared to how much I used to produce the back emf. Then, by getting my rotors to go very fast, say maybe 5000 rpms or higher, it leaves me a lot of room to load the rotor with charging coils, down to lets say 2000 rpm, loaded, then hopefully what ever we got in charge coils, could be higher than the difference between bat power used and back emf gain, which should be enough in bemf and charge to eliminate the battery. If we were to get to that point, develop it into something that either produces excess power electrically or mechanically.
Werd.
But Im sure someone here would help you that has more experience than me.
There is a vid on yt, this guy was charging his input bat and a second bat.
But who knows, till ya do it. =]

magluvin