Hilden-Brand Magnet Motor

[JackH]

Hello Honk,

[Rosphere]

Has anyone tried a composite of pure iron powder say 100 mesh with epoxy pressed mold and cured under magnetic force to train the particles till fully cured?

I have done this with coil cores but nothing like this.

Almost.  I was using a #11 to chip the fully cured JB-Weld epoxy off the neo-magnets I was trying to reclaim from a failed magnet motor I had made a month before.  These little chips had an annoying habit of clinging to the magnet, making cleaning more difficult.

I was not surprised.  I noticed earlier that the uncured black epoxy, that I had placed on my disc, formed tiny little stalagmites as I brought the magnet closer to the glue to crush them.  Then, I noticed the JB-weld creeping up the sides of the magnet, from the bottom.  I screamed like a little girl and fainted. 

I suspect that there is iron in this epoxy.  I did not experiment with the chips to see if they had a magnetic alignment.  They may or may not have.  All I can honestly report is that they were attracted to the magnets after being chipped off.

Are you going somewhere with this?

[Honk]

Now I need to be very carefull of what I say here.   My patents were supossed to be completed no later than late December of last year.   I have been told that two areas of the US military have been looking at my patent forms.  And I have been told that they may become classified material.   If that happens, I am out of business.  That is why I have been realeasing more and more of the materials I have at this site.

Later,,,,,JackH

Please continue to release your great free energy inventions.
Free speach and research should never be stopped.
Once you have planted the seed here, it will continue to grow all over the world.
And free energy for everyone will be unstoppable.

[tsakou]

Now I need to be very carefull of what I say here.   My patents were supossed to be completed no later than late December of last year.   I have been told that two areas of the US military have been looking at my patent forms.  And I have neen told that they may become clasified material.   If that happins, I am out of business.  That is why I have been realeasing more and more of the materials I have at this site.


Later,,,,,JackH

I believe that open sourcing is much better than patents. If you try to make a buck out of it (with patents), someone will try to stop you. Anything put on the web stays forever because of easy copying. Good Luck with your efforts.


Greetings,

Tsakou

[Honk]

Hi Jack.

Is it OK with you if I ask you some questions?

You have told us that your motors are more efficient at low RPM.
But how can you tell the RPM when planning a new motor of yours?
Is it the size of the motor or is it the number of field poles?

I hope you would like to share this info with us.

Regards / Honk