magnet-gravity wheel

[CLaNZeR]

CLaNZeR the sliders are not sliding freely enough this is very important. let me know how it goes.


peace

p.s. will need to build this wheel myself too

Shame we lost all the posts from yesterday as I replied to this already LOL

The arms are sliding really smooth and should be with the THK rails being used, I am thinking it is more balance than the rails.

If you look at the picture below you can see that maybe I need to mill out a new square and butt the end of the sliders closer together. In other words get rid of the 8mm gap in front of each slider and reduce to 2mm and also with the 6mm gap reduce it to 2mm.



Like I said, will play more when I get the time, I want to get the pulse controller version 4 code finished this week and again a long thread on this got loast yesterday when the server went down grrrrrrrrr, I have updated my site with it though.

Regards

Sean.

[FreeEnergy]

thanks

[FreeEnergy]

we must try every possibly way

peace

[FreeEnergy]

by the lifting of only arm A there is enough dis imbalanced momentum to the whole wheel that causes arm C to shift its weight to the right, by this time there is leverage weight arm C and D going against the sticky spot; overcoming the sticky spot?

must be a one-way wheel.


peace

[FreeEnergy]

at 22 seconds of the video you can see the arm is not sliding freely enough.

also could you post a video with the smot setup the way i explained?

thanks