Quote from: electricme on November 03, 2009, 01:00:36 AM
Hi everyone,
I just posted my design for a new engine here on this thread.

http://www.overunity.com/index.php?topic=7769.new#new

I did it here to keep it out of this thread, maybe Stefan can make a separate thread for it when he is ready, as I don't know how to do it.

jim electricme inventor of the DUDGEON ENGINE

I'm curious about this new engine, but I went through 6 pages from the link you provided and saw nothing engine related. Can you provide me a direct link please?

Thank you.

t3t4:

Here is the correct link:  http://www.overunity.com/index.php?topic=8247.0
This should take you to page 1.


Bill

Hi Everybody,

After reading through this whole thread I decided to build an Earth Battery.  My first try resulted in 1.7 volts 13 milliamps.  I was able to light a LED directly off it continuously.  I also ran a calculator off it.  I have built a lot of water, lemon batteries, etc.  None of them worked nearly as well as this.  I charged a completely empty bcap 650f overnight on the earth battery and then ran a small electric motor off it for over four hours.  Here is the video link: http://www.youtube.com/watch?v=jAHmHm5vNA4

I look forward to participating on this great forum.  I will continue to share my findings.

Merry Christmas,
LaserSaber

Excellent video!!

Your output is up there with the best of them, that is nice work.  Now that you are using your b-cap, you will be able to do amazing things.

A word of advice on Youtube...just ignore the naysayers that will post things like..."fake", "that's not free energy" etc.  You will also get a lot of good comments from folks that know this can be done.

Can you explain your set-up?  Materials, alignments, etc?  Your output is up there in the range of the best I have seen.  If you just started using it, it will probably go up in a little while.

One other question:  Your volt output is 1.7 volts, when you fill your b-cap, do you see a much higher voltage on the b-cap than your 1.7 volts like I do?  If so, then this is another confirmation of the spikes being stored in the b-cap as usable power.

I am glad you are here with us and look forward to seeing more of your experiments.

Bill

Hi Pirate88179,

Your videos are what inspired me to start experimenting with this in the first place.  Thanks for taking the time to post them.

I am on the road right now, but when I get back I will take a video showing and explaining my earth battery setup.  I will say that I used a bundle of half inch carbon rods and one copper rod on the north end.  On the south end I used a 1 inch magnesium rod stuck vertically in the ground.  Attached to the magnesium rod I laid down 75 feet of magnesium ribbon 6 inches underground running south.  Prior to adding the ribbon I was getting 1.5 volts at 3 milliamps.  Adding the ribbon really upped my milliamps.

I have not left the capacitor on the earth battery long enough to establish how high it will charge in voltage.  Do you use a joule thief to charge your capacitor off of your earth battery?  I just connected my capacitor to the + and â€" leads of my earth battery.  What are the dangers of getting shocked with one of these capacitors?