Based upon Fatbird's post about clock synchronization, I will not undo Otto's jumpers on  GK4 but will jumper GK3(fatter gauge though) to put the 3 layers in parallel, modify the quadrature control down to 1 block of 4 channels instead of 2 blocks of 8 channels. Right now both 74ls193 are count up linked so I have 8 channels running. I will run off of one 74ls193. That will give control to 4 sets. The key was 3 frequencies. Vague talk again for 3 input signals. That frequency is to be tuned to the coils diameter or circumference. This will let me get the compass spinning.
Then I connect my GK4! And the monster should breathe fire, eh?
When I reported my results on the heat & energy waves. They didn't last long because of the constant out of phasing condition only working with harmonics. The off harmonic is the confusion. I saw that many times changing freqs.
Hmmmm. I am all over this.

--giantkilller.

Hi giantkiller, FatBird, all,
Mannix just posted about the CMOSmax308
http://www.rtcs.ru/pdf/Maxim/switch/MAX308-MAX309.pdf

Quote from: Mannix on January 16, 2007, 06:32:18 PM
Im using ss max308 sources.

I connected the output of the tongtail phase splitter...very low level. Then observed the wave form on the collector. I freq only. the other amps are still not quite complete.

what I saw at 30 khz was a little waver....just a tiny waver.

I have used these in the past. They are excellant products. Maxim as a whole produces a wide array of conversion products. Their RS-232 single chip TX/RC are great!

--giantkiller.

One way you can limit the heating effect of the collector coils is my making them out of 1/4 or 1/8 inch diameter copper tubing.  Then you run water through them.  You now have water heater and an energy system for your home.

All,
I figured I would post a photo of my progress. TPU_004 under construction. That is 15 turns of 10ga solid copper in the core and 20ga magnet wire for the control winding.

TPU_003 is also in the picture. All three control windings are wound on a solid copper core of single turns I wire in parallel.

I haven't seen anything I would consider unusual to date. But I'm not doing my tests exactly as GK or Otto. I figure we already have testers/investigators moving that direction and posting their findings. I still have to figure out how I'm going to move a geomagnetic line of force and then let it recoil in a controlled fashion. Consider this, when a solar flare disturbs the geomagnetic fields, in some cases FREAKING HUGE quantities of energy are coupled. We are apparently seeking to perform a similar task except we are right in the middle of the field. Movin forward.

Regards,
JT