Welcome back my friends,
to the show that never ends,
We're so glad you could attend,
come inside, come inside...

Let's talk about the main 2 coil designs.
The first one is the SM4 & SM6.
Theses have the feedback coils encompassing the whole unit.

The SM15 & SM17 have their feedback coils close to the center of the ring. Near the highest concentration of flux.
It is as I had posted all those 3d wave diagrams before.

The 4 & 6 are refered to as coils while the 15 & 17 are refered to as rings.

Steven Mark is an accomplished audio engineer.
That gave the idea to use my guitar with a sound processor as a magnetic field and interference pick up device. The sound processor enabled me to hear freqs out of range. Eddy Van Halen 'Eat your heart out'.

So when I saw the 2 coils in the 15 and 17 above the control box I realized that they are the feedbacks.

Ready for the drum roll?

The rings uses 2 frequencies to clash together and create a high powered, very high frequency wave that travels from the ring outward and inward! This inward wave is the one we want because it wipes across the control box coils in a compressing wave of energy at a concentrated point.
And the drums are getting louder! And remember the phrase 'It takes a moment to ramp up'?

Steven has placed 2 microphones inside the speaker in the amplification feedback loop!
Did you get that!
Did you get that!
Did you get that!
Did you get that!
Did you get that!
Did you get that!
Did you get that!
Did you get that!
Did you get that!
My job is done.
How fast can you blow an amp?  The coils and rings are speakers. Thank you Marco.
This has been very, very real for me!
All the musicians here stand and take a bow. You know what I am talking about!

The accompanying thread is paradyme gear shift forward. For those of you that didn't check out www.Paradyme.com. It is a privately held audio supply company in California. Remember any of these clues?
The gear is audio not auto! And the shift forward was connected to the dolphin poem by sonny which was a  clear reference to Dave & Marco demos and then me. I am the reference of the dolphin.

I think I earned me keep, today. RFC as always. Let's blow some s**t up today!

--giantkiller. Shift happens...

Quote by moab
Frequencies are the key to the kicks. Your coils are different than mine, and so to will be your freq. This is not a one freq fits all undertaking.THIS is important.don't bother with two or three at a time stick to one until you have kicks on your scope or a squealing on your am radio if you don't have a scope. when you have kicks move on to the next freq and try. I only had to make two the third IS resonance.you wont mistake it when you stumble upon it.







remember when i said that i only had to make two and the third IS RESONANCE? this is what we are looking fore. Just find the right two frequencies for YOUR coils and the third will happen all by its self. Moab

Parts arrive tomorrow on the truck..................just finished my cross compiler build....CRAZY magnets to follow.....................very interesting.

 

I'm using a KwikByte ARM Devel board to handle the control functions. Driving MOSFETS with driver chips triggered by computer sensed feedback signals. My gens are DDS, 125MHz clock with .02Hz resolution, digitally tuned freqs and 11.5 deg phase control res. We'll see very shortly if this approach is sound or not. Once I find my coils sweet spot and tuning I'll post the schematic diags. If I get some interesting graphics I'll try to get some video up. I have to go back and look up Tesla's descriptions of the various EM discharges. Man it would have been cool to see Nicola with modern computing power and material science................C'mon truck.....Bring my shift.......