Maybee im too stupid or maybee im a genuis
but if you have a negative ohm does that mean you crossed
zero point if it does then I can tell you where zero is
Im prety shure there referring to this
water as negative water in joe cell
not really shure I dont understand ohm
that much maybee negative is normal
what exactly is a negative ohm ill try to search it
he has the right thing i know thats tesla box
he moves that flourescent between two fields zero point is the middle
where it goes out it can eith goe out and stay off or
cross over and stay lit he has the zero point circuit no doubt.
Ask nice beg if you have too.

I shhouuld add the only real difference I can see between moray
valve and teslas black box is the ground
goes to another antenna which
he demonstrates at the end of spacial energy
no ground rod that is actualy the best system
the ground rod will cause radiation to build
which is probly why goverment smashed it
not shure by the way inctlc has info on manhatten
project was named after teslas earthquake
so that puts the whole einstien nuke
as not likely the city was leveled most likely leveled
using tesla scalar wave. And same as 911
the planes were the hydrogen bomb lol
think were stupid do you fucking lieing ass Goverment
maybee they have a nuke but I dont think so
i think it was a hydrogen Bomb to begin with
maybee the bomb had tesla mahattan earth
quake box in it could been in the city
or thru earth life as you know it is changing.

Ok ill do my best to explain zero point energy
the vacume and pressure determines
resistance the air from here to there has resistence
the vacume minimizes or eliminates the resistence
so where and how do you find Zero point
energy Its right in front of you.
The myan pyramid has no cap why?
The 4 points of the square go to the 5
point the peak but the peak overlaps
so the zero point can range any where from
the peak of the star of david to the bottom
the exact center is the middle of zero point
so the flourescent has 4 prongs the four
corners of the pyramid With no cap
the zero point energy can range anywhere
in that bulb why? Well at first the vacume is
low but as it rises the vacume is less
the vacume can fluctuates any where in the bulb
anywhere the zero point energy is betwen pressure and vacume
the the bulb is Zero point so
because the bulb has no resistence
put the resistence back in to match
this would be from air the antenna
when the resistence from air matches the vacume
you get zero point the tesla coils emit
a frequency that must magnify the
resistence to match the bulb that lights it wireless
if you match the resistance from air
by adding in dr stifflers case he started with a
pressurised incandescent a small one
why? The incandescent has a pressure to provide more resistance
to the fillament without that resistance it would burn up
so matching the two he some how found the middle.
That doesnt need a flourescent or incandescent
but led so he some how parralled
the led between a resistor and vacume
the only thing I can think removes resistance
is the inductor so the inductor tuned essentualy
creates the vacume on both side of the led
the led is the resistance. When the vacume matches the resistence
you should always Have free power.
So the Joe cell by pluging the carb
creates a vacume in the piston the joe cell
is a pressure the middle between the vacume
it could also be the pressure either one
depending on how you decide to run the motor
well I did my best Ill try to design a drawing
for you the Nas battery is the same principle
the warm pressure is in the middle it seems
Dr stiffler made the flourescen the exact
middle in video 3 the plates are the cut tops of the pyramid
so the incandecent was the resisentence
and the resistence increased as he added bulbs as the light gets brighter
thats why you only saw two so if you add
more incandecents as you add flourecents the
ground resistence = the input power
eventualy the input power will be too low it will need
more resitors to match the ground
so any power source is essentialy unlimited if you match the resistence on
each side to the vacume well hope that helps
maybey sone one can hook me up when you get it built.
Peace thanks Dr Stifler. For the Great video
I knoticed You were a little frustrated on the wireless hydrogen
I think You did a Good Job and Your comments were down so
I tell you from here That I apreciate Your Work.
Cletus 
 

   

So ground is a vacume
air is resistor
ac is a vacume

So ac - vacume, incandescent pressure
resistor, Ground Vacume.

So ac vacume ballast must be a resistor
flourescent vacume ,ballast resistor,ground vacume.

A closed loop coil is vacume on inductor
as rod passes thru breaks the vacume
must pass the resistor/resistance to go back to the coil
as vacume is broke the vacume is passed to the ac.

Hope that helps Im praying I say it all right.
As you guys know I cant wire a board.
Stupid huh. Like playing music cant do that either
maybee now I understand it better who knows.
Dont sound like I need a board maybee
I can do this so we need a vacume that equals the ground
ya beings air is a resistor morays seems tougher
oh i see add a resistor to the ground rod
tune the restitance to air then put a vacume on each side
of the pressure bulbs so his cells were just any rock
that creates a vacume that you can tune
the resistance to. Once the vacume and
resistence matches the cell as long as the
middle ressitance is stabke you be cool
but the ac in a house fluctuates so we need
a series of adjustable resistors like the
and vacume that can change as the load changes
like the incandecent gets brighter
as you increase the vacume we need a vacume that gets more as we increase
resistance. A self tuning inductor should do
im shure you guys can figure that out.   

I was thinking like a two way switch
so when the light is turned off it doesnt lose resistence
and change the tuning it will just be switched to a resistor
that equals say a 60 watt incandescent that sounds practical
so you could tune the house and just have a small
battery section for the items that fluctuate
more like motors would need a stable
dc charger that swaps to a resistor when its not charging
so the dc can them fluctuate as needed
with a ac inverter so like your fridge your
air things that kick on and off
will need a stabllizer mabey just a inductor would do
seems like if we get things right they will get implimented pretty fast
incandescent seem to have a big range
beings the power will be free it wont matter
the energy bill just easiest to tune it.
I was thinking the ballast should make hydrogen
extremly fast if its a resistor water a vacume
then both sides that go to the bulb
should really get the hydrogen going.