Quote from: verpies on May 17, 2014, 06:33:37 PM
According to Avalon it is more than that.
In this post he writes that he is getting 500-600V under load and some power anomalies

I'd sure like to see some solid evidence of those high voltages. Scopeshots, with confirmation that probe and scope channel attenuations are set properly, and a measurement made on a _known_ high voltage source with the same probe/channel settings, for comparison. There may be other spurious sources of high-voltage readings as well, such as stray inductances.

An illustration, from a different experiment,  of high... and spurious.... voltage readings caused by stray inductance in the measurement circuit:
http://www.youtube.com/watch?v=ufEZW5iTv6Y
When the battery voltage is measured _properly_ it can be seen that all of that voltage oscillation amplitude is just due to stray induction and is _not_ reflecting anything real happening at the battery.

@TinselKoala
I'd like that, too.  Those are valid concerns.

On the other hand I know that it is possible to get those kinds of voltages from JT-type systems running on very low input voltages. I still want to see some confirmation, though.

Попробовал использовать заводскую катушку от БП просто для проверки возбуждения контура.
Для тех кто не любит мотать

Quote from: semenihin-77 on May 19, 2014, 04:42:19 AM
Попробовал использовать заводскую катушку от БП просто для проверки возбуждения контура.
Для тех кто не любит мотать


http://youtu.be/auEuQgW-qek

that you? то есть вы?
is that running on power?