F.Y.I.
May assist in understanding fundamental theories, design, and other!

CircuitMason =>  "free, full featured frequency domain RF circuit simulator" [Eng].

http://www.circuitmason.com/

{Excellent tool (IMHO); complements CST Studio Suite and other tools.}

Traveling Wave versus Standing Wave (e.g.):
https://www.youtube.com/watch?v=2KBJp5ysS74

Traveling Wave (e.g.):
https://www.youtube.com/watch?v=fStJBxrqEuM

Thank you much Mr. Gregory Kiesel (creator of Wave Mason & Circuit Mason).
Youtube Channel examples:
https://www.youtube.com/user/SidewaysTheDog/videos

  When I connect my 37.5 meter ground line, to the Kacher transistor base, or at the starting of the secondary coil, I get no oscillations. I have to connect this ground line to the transistor emitter, instead.
  If I connect the Kacher to a shorter (5m) ground line and a earth ground rod, it adds only very little to the output of the Tesla coil. Almost nothing is noticed.
  However, my 37.5m ground line going into my water well, does add to both the Kacher as well as to the induction circuits output at the bulbs.

  Solar Lab:  You mentioned, "May assist in understanding fundamental theories,"
  I don't think that any of our current scientists really understands the fundamental principals of what "waves" really are, at all.   I'm not trying to be comical...
 
   There is nothing "traveling"  there is no "movement" in any wave. They propagate by polarization, instead.
Without traveling.
  I know that most people won't believe me, that's ok. Then just believe what you have been told, if it suits you. But, the proof is to show, just what they think is "traveling".  Show how it goes from point A to point B.

  There are no electrons, photons, or anything else traveling in a radio wave from Pluto to here, in radio communication with the probe. Their signal is not traveling to get here, yet it does propagate, just the same. Sunlight does not travel through space to get here, either. If it did, it would never make it. As light diminishes by the square root of the distance from it's source.
  What does this have to do with free energy.  Everything...

  Witching rods also need to be tuned for the frequencies that they are trying to tune in to.
  REJECTED, BY SCIENTIST???  They reject what they can't prove...
  http://news.yahoo.com/water-witch-dowsing-california-drought-145325572.html

T-1000, this diode which is to be inversely as he drew says there are many?
transistor which says it is the middle of mosfet ?
25:45
https://www.youtube.com/watch?v=f1a1qcvNLVU
(the high frequency which indicates that the pulses are on a high 1.5MHz. a primary coil)

I look for this film, where Ruslan tells us that he used another transistor
Nickz from the beginning of the pulse was used transistor (KT805) during assembly Dally.
and I have not seen that this system Kacher you could substitute in getting this job
therefore without driver and pulses are already forget that the same single transistor something here to change.
will show you what's wrong here

 
for here the driver and transistor here is important

https://www.youtube.com/watch?v=e3AJ9fy4tB0
2:30
check this transistor