Piezo output.

Two tuning fork shaped Piezo hammers can seat into ring magnet core holes with nylon washers cushioning the magnets. A hammer head could pound Piezo chips with the ends of the forks that would fit around the sides of the switches and butt up against the ferrite rod inside. This would help protect the Neo magnets from contact damage.

Quote from: kampen on April 15, 2019, 02:05:41 PM
Dear Synchro1,

Thanks for your reply.
Since the theory seems to work on a small scale model (proof of concept) You made also a working prototype.
Do You have any plans to up-scale this?

One plan calls for a radial motor of "H' bridge solenoids. Imagine 8 or 32 of these types of bidirectional power stroke pistons, perhaps with longer coil dimensions and throw, all connected to a cam lobe center axle.


The motor would be returning it's power pulse to a storage capacitor. What would take place if we increased the input power to do increased work with the motor axle?


The BEMF would increase in direct proportion to the input power, and the motor generator would continue to run at unity while delivering more work force.

https://worldwide.espacenet.com/publicationDetails/biblio?DB=EPODOC&II=26&ND=3&adjacent=true&locale=en_EP&FT=D&date=19821007&CC=DE&NR=3039176A1&KC=A1#
Lever and - arm and many solenoids/ electro-magnets on a wheel( or multiple wheels)


Some years later as " improvement" applied :
https://worldwide.espacenet.com/publicationDetails/biblio?DB=EPODOC&II=25&ND=3&adjacent=true&locale=en_EP&FT=D&date=19900215&CC=DE&NR=3826970A1&KC=A1#

This guy is running his 8 cylinder solenoid radial with 8 SPDT micro lever limit switches:

https://www.youtube.com/watch?v=QY-JegKaheo

synchro1,

I must be thick headed, but I can not for the life of me figure out how you wired your working oscillator. Will you please post a complete digram along with the diode(s) and cap?

I would really appreciate it.

Thank you.