Quote from: JustMe on April 11, 2008, 12:41:55 PM
I'll try Lurker's suggestion for the data presentation, and maybe those who have an interest can indicate which they prefer.

@Justme
I like the tabel best. It's good to put just one pic to show the setup tho. The pics havea yellow memter called VOLTS IN but the table doen't inlcude that, it uses the grey box meter - whats the difference, which is the right one for input volts? Also would it be possible to fill in the -?- numbers in the table because there hard to read from the pics. Much appreciate
-Mike

To all those who have put so much into this I am very sorry for messing around with the thread title, it will now be titled "Thane Heins Perepiteia." and will be left alone, again I'm sorry, enjoy folks.

Quote from: springfield on April 14, 2008, 01:38:45 AM
@Justme
I like the tabel best. It's good to put just one pic to show the setup tho. The pics havea yellow memter called VOLTS IN but the table doen't inlcude that, it uses the grey box meter - whats the difference, which is the right one for input volts? Also would it be possible to fill in the -?- numbers in the table because there hard to read from the pics. Much appreciate
-Mike

Hi Mike,

I am assisting with the pictures, which I receive via e-mail.  I don't have access to any data outside what I can see on the pictures either, so that's why there are '?' where the digits are unreadable.  The pictures are usually quite clear, so any future ones are unlikely have this issue again.

I checked with Thane on the input volts issue before I put the table together and he suggested I use the volts measurement from the power analyzer (grey box) because it was true RMS.

Quote from: RunningBare on April 14, 2008, 04:23:47 AM
To all those who have put so much into this I am very sorry for messing around with the thread title, it will now be titled "Thane Heins Perepiteia." and will be left alone, again I'm sorry, enjoy folks.

Thanks RunningBare - I know that will be appreciated.  Thanks also to Aether22 and Mr. Entropy for helping it happen.

Hi Thane,

Has the new setup with the right motor running and the left motor not running, but all still accelerating, been tested with your non-magnetic rotor coupling setup to the left motor?

Thanks,
Larry