another small breakthrough on our NERD technology.

[Rosemary Ainslie]

@MH: You are confusing me with all these LEDs. Could you please draw a diagram for me? I've got lots of red and green LEDs to blow up and I like doing it.

@.99: I am glad the sim sees the limiting of the voltage that the gate driver puts out.... If I am understanding you correctly this happens in the real circuit too, it's what I've been calling "draw down" as if the FG were heavily loaded by a low impedance load. However, increasing the amplitude of the FG output at this point causes an increase in _current_ but not voltage. And I think Rosemary's Instek is doing this too, based on the reports and scope traces.

Meanwhile, back at the ranch..... What's that, Lassie? Timmy is stuck in the well..... again ?

http://www.youtube.com/watch?v=IkIKGf_2bt0

I no longer watch your videos TK.  I find the lighting way too suspect.  But hopefully your 'followers' will rally.  And you really do need a manicure.  Or just try soap and water.  It works rather well.

Rosie Poser

[MileHigh]

Boom!

[Rosemary Ainslie]

Boom!

golly

[Rosemary Ainslie]

@Rosemary: Your seven collaborators: Contact information please. Your raw data: make it available for inspection please.

@TK:   Your name: Contact information please.  Your raw data: make it available for inspection please.

[MileHigh]

Rosie Posie:

It IS there in the demo vid.  It is NOT there in the tests relating to our paper.

So the demo clip is complete junk and should be ignored?  Is that what you are saying?

My spider senses are sensing some mendacious mendacities.

I no longer watch your videos TK.  I find the lighting way too suspect.  But hopefully your 'followers' will rally.

Little Miss Dismissive MOSFET,
Dissing the world away.
Such poor manners,
Dreams of trolls and spammers,
Mendacious, I would say!

MileHigh