Using Chas Cambel Flywheel System For 15 Horsepower

[tinman]

I have also read that pulsing a dc motor will greatly improve its efficiency and I can c how but has anybody had success doing it.  I haven't seen it yet.   Thanks

Pulsing a DC motor will NOT increase it's electrical P/in to mechanical P/out ratio.

[markdansie]

Pulsing a DC motor will NOT increase it's electrical P/in to mechanical P/out ratio.

It is the biggest cause of mis-measurement I have found out there to those who believe they can
Mark

[Marsing]

Pulsing a DC motor will NOT increase it's electrical P/in to mechanical P/out ratio.

...

It is the biggest cause of mis-measurement I have found out there to those who believe they can
Mark

hi..   markdansie & tinman

this is about pulse DC.  both of you must be familiar with pict bellow, what do you think?
sorry, i am out of topic.

[Paul-R]

I have also read that pulsing a dc motor will greatly improve its efficiency

This is part of the story and not the whole thing.

Bedini is full of pulsing, as is Bob Boyce's water fracturing technology. Chas Campbell has mechanical pulsing. Pulsing is all over the place but be mindful of a need to maximise through resonance where appropriate.

[No clue 25]

So has anybody thought of using a servo or stepper motor to generate with.  It seems to me like there is not much confidence in the chas campbell design even with several replicas on YouTube supposedly producing power.  Is the key to the system matching the rpm of the two motors or could you have different wheels at different rpm and use them to take the shock of large loads and maybe use one way clutch so if they slow down to much it will cut the generator side and recharge the wheels again?