Kapanadze Cousin - DALLY FREE ENERGY

[NickZ]

   Jeg:   I hope that you can build the Poma (Roma, same guy) Poma Prill, device. The non working device that was sold, may be something else.  I did spend some time studying that device, but as not everything is known nor shown about it, I didn't want to have to guess about what is hidden or not mentioned about it.   Good luck with that.

[NickZ]

Hi, Guys,
My Ruslan 7 replika with 500W halogen bulb. The frequency has doubled when i start Kacher.

  Conoco: looks nice and neet. Did you have any luck with it self running?

[conico]

I didn't try self running, I have just 72-80 Vrms on the load.
I forgot, Kather at 892Khz, inductor and wima cap work at 15.3Khz the outcome is 30.5Khz on the load.
When i start Kather the current from batteries has risen from 2 A to 7A.
The device work the same without ground may be a little low , just 6.4 A from batteries.

Jeg, you were right, that device with two Tesla coils, (Poma or Roma device) is working, you post a diagram one year ago, I try it until the mosfet from Katcher has been destroyed, but a lot of energy was there.

[AlienGrey]

I didn't try self running, I have just 72-80 Vrms on the load.
I forgot, Kather at 892Khz, inductor and wima cap work at 15.3Khz the outcome is 30.5Khz on the load.
When i start Kather the current from batteries has risen from 2 A to 7A.
The device work the same without ground may be a little low , just 6.4 A from batteries.

Jeg, you were right, that device with two Tesla coils is working, you post a diagram one year ago, I try it until the mosfet from Katcher has been destroyed, but a lot of energy was there.

Hi that Katcher frequency is as bit low can you get it any higher ? to at least 1.5mhz?
and have you set up the yoke and inductor xl and xc tuned up or you get loses if 892 is highest you can get try tuning yoke and push-pull to 17.84khz

[conico]

I put the function generator on ''antenna'' and the scop show me a maximum amplitude of grenade coil at 840 to 860 Khz and an other point  was at 3.4Mhz. I didn't succeed with Katcher at 3.4Mhz.
Anyway I don't like Ruslan devices you can not start them with 9V battery. The devices must be simple, Kapanadze said.
I try to tune the inductor and series cap at 60th of harmonic of 860 khz, first the device work at 14,xx Khz but is the same result as now