Kapanadze Cousin - DALLY FREE ENERGY

[Void]

It is what we need for playing with Acula's solid state circuits.

Hi Jeg. Why do you think that?

And finally, Akula is MIA.  Nor has he shown any brand new Mercedes parked in his drive way.

As I mentioned above, Akula 'liked' a video on his youtube channel a couple of weeks ago,
so apparently he is out there somewhere. Whether he has made any business deals in regards
to his devices really isn't dependent on him showing a brand new Mercedes in his driveway.
If his devices have proven to be too unstable, then that might be a problem for him.
I have to wonder if at least some of his claimed LED driver self runners were just powering from nearby cell towers
or similar, however. It doesn't take all that much power to power up a few LEDs, but I would assume Akula would have
tested for that possibility to try to rule that out.

[AlienGrey]

Hi Jeg. Why do you think that?


As I mentioned above, Akula 'liked' a video on his youtube channel a couple of weeks ago,
so apparently, he is out there somewhere. Whether he has made any business deals in regards to his devices really isn't dependent on him showing a brand new Mercedes in his driveway.
If his devices have proven to be too unstable, then that might be a problem for him.
I have to wonder if at least some of his claimed LED driver self-runners were just powering from nearby cell towers or similar, however. It doesn't take all that much power to power up a few LEDs, but I would assume Akula would have tested for that possibility to try to rule that out.

Have you forget the quarter wave that Wesley referred to and various guys displayed and used etc has anyone thought of experimenting with that idea to see if it works

A vfo cd4046 driving a dual cd4013 and some LEDs ?

[Jeg]

Hi Jeg. Why do you think that?

Because we need high frequency resonance don't we? Acula has already stated, that all of his devices are based on the same effect and method to reproduce it. So it is safe to assume that in his above system with just one switch there has to be a way to produce both the high and low frequency together. Just saying..

[Jeg]

Void check this out. The man of the channel answers on how to get this signal. Can you understand completely what he says?

Высокочастотный сигнал генерит ТЛ494. Паузы между ними делают усилители ошибки по параметру степени насыщения феррита. По сути тут два генератора первый на внутреннем генераторе 494, а второй параметрический зависящей от силы тока протекающего через L1 снимаемый на шунте R1.

In his video he makes a new connection to pin No.16 which is one of the two error amplifiers. But wire isn't coming from R1 as he states but from the output instead. Perhaps there are more on this but it is in Russian.

[apecore]

A G. , an advice on the Russian forums, uses only the harmonics multiples of 3, that is 30th, 60th, 90th, in your case may be 90th.
 
I have two more pictures taken from the forums, I do not remember which forum,
these pictures reveal the secret of how to tune Ruslan devices.
I found these pictures yesterday on my computer but they were two years old.

Thanks Conico,

I believe this is very good information it fits in the M.O. as i am currently aware of.
If you have more topics to share from these Russian forums i recommend it strongly.


Best regards