Kapanadze Cousin - DALLY FREE ENERGY

[a.king21]

New Kapanadze video.





[/size]This video was sent to me by a Kapanadze insider who was unhappy with the way he was doing business. Unfortunately it is in Georgian and a translation from any Georgian speaker would be welcome. I don't think it helps us much as the video is filmed entirely under Kapanadze's free energy lights. However it is yet another device to add to his collection....[/size]I have called it aquarium 4.



The link is https://www.youtube.com/watch?v=3s-4...ature=youtu.be

[Tomtech29]

TT,

in this video:  https://www.youtube.com/watch?v=dJWwQUdQ_RU  you can see that  at 1:34 he removes a probe, and after that, the green trace on the scope is flat.
So this must be the point at which he was taking this stroboscope green trace from, see red circle below.


Itsu

you're irreplaceable so I have not seen this video.
I wonder how many windings is to have this small toroid ( current measuremen) tand how much has uH.?
I try to keep strictly to the scheme later to understand how it is to operate
Thank you for your patience and understanding.

[MenofFather]

Yes agrees to the switch should be in position "R" I get it now ,and where to look for the green waveform amplitudę?
as the frequency to check whether so it seems that in this regard I see just something about 230Khz?

Seems you osciloscope can not normaly sinchronisate and it shows 230 khz, while real frenquency is seems about 1.5 megaherc.


And you need swithing jumper, seems, to get package or one nanopulse.

[MenofFather]

Well as you could see, "the series resonance does NOT output sine wave out of grenade" without caps, its squared because of the load (100W bulb) behind the FWBR and has some oscillations at the sides.
Not sure where these oscillations come from as the series resonance LC signal (both voltage and current) are nice clean sine waves.

The nano-pulse width is about 12ns, the grenade output squarisch wave is 20us, so nowhere near your "half of that sine wave".
I can influence the nano-pulser input pulse (80 - 500ns), but not the output pulse.


Itsu

Ruslan say in one video, that pulse durantion must be not 1 nanosecond, but one microsecond, then he comment dally schematic of mikmur.

[MenofFather]

...
As mentioned above, i cannot adjust the nano-pulse output width, its kind of fixed at 12ns ...

Itsu

If you change from you small ferite ring ends of primary or secondary windings, then you can get on output pulse with different duration. And then your setup be like dally and Ruslan and then you can easyly get pulse duration 200 ns.