1939 Gravity Power - multiply power by 1200%

[gotoluc]

@centraflow

Mike, thanks for looking in an elliptical mechanical solution!... doesn't look like an easy thing to do.
Also, have a look at the new attached test 3 video with universal joint. I stopped the weights for you, so you can see the lever drive continues on with no problem.



@mscoffman
Thanks for your analysis of the mechanical actions


@I_ron
That was my hope that it would work with the lower shaft off center but unfortunately it is not enough. See the test video.


Link to new video: https://www.youtube.com/watch?v=Hvy7zuWKaF4&feature=youtu.be

[havuhung]

Now looking for recommendations on how I can easily convert my top gear so the lever is turned in an elliptical orbit to further test this possibility of being the right thing.

Luc

Hi gotoluc,
To create motion elliptical shape, structural mechanics have a following way: two coaxial discs rotate in the opposite direction with the arm length difference, probably easiest done.
                     Simulation video clip: http://youtu.be/Omsge0rQbe8

Regards

[turbogt16v]

hy luc

I don't know if you would listen to me but i will still say my opinion,
1.you need to get rid of that lace on the 2 weight ,it is lowering the output power
2.the plate is straingt not bend on the 1 weight,don't know why you did that
3.looking from the top down ,the 1 weight is at 12 o clock ,and 2 weight is at 9 o clock,input lever is at center, see video
4.you need a bearing on 1 weight not because you can freely stop top , but because then it need less input power
5.fix lever at gimbal,it will cause less pressure on weights so they will move with less friction

[gotoluc]

Hi gotoluc,
To create motion elliptical shape, structural mechanics have a following way: two coaxial discs rotate in the opposite direction with the arm length difference, probably easiest done.
                     Simulation video clip: http://youtu.be/Omsge0rQbe8

Regards

Good elliptical mechanism havuhung

Thanks for sharing

Luc

[gotoluc]

hy luc

I don't know if you would listen to me but i will still say my opinion,
1.you need to get rid of that lace on the 2 weight ,it is lowering the output power
2.the plate is straingt not bend on the 1 weight,don't know why you did that
3.looking from the top down ,the 1 weight is at 12 o clock ,and 2 weight is at 9 o clock,input lever is at center, see video
4.you need a bearing on 1 weight not because you can freely stop top , but because then it need less input power
5.fix lever at gimbal,it will cause less pressure on weights so they will move with less friction

Thanks for your opinions

Luc