Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Problem with lm2576 in the circuit?

Started by Vickysong, June 07, 2017, 02:14:27 AM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Print
Go Down Pages1
User actions

Vickysong

June 07, 2017, 02:14:27 AM
As shown in the above, the output voltage of lm2576 is a stable adjustable voltage.
Fault phenomenon: voltage falls sharply after the connection to the load, and the motor can not run.
My testing work: (1) when the load is connected, I open. The input voltage is only 2.56 V, and output is 1.56 V, which is unable to drive the motor (normally input is 7.56 V and output is 5-12 V adjusted by potentiometer). The datasheet of LM2576 is here http://www.hkinventory.com
(2) after I replace the new battery, it is the same.
(3) I disconnect the load, the the 2576 works normally (input normally, and the output is adjustable)
(4) the resistance of motor is 0.8 ohm. unknown inductance is 2.7 ohm.
(5) the circuit diagram is incomplete because it is based on my drawing line followed circuit boards
(6) entity is a flow adjustable vacuum pump




Jeg

#1
June 09, 2017, 06:50:46 AM
Quote from: Vickysong on June 07, 2017, 02:14:27 AM

(5) the circuit diagram is incomplete because it is based on my drawing line followed circuit boards


Hallo Vickysong :)
Don't expect much help when there is not any circuit drawing. Have you implemented the circuit as per data sheet? Look at page 14 of the attached datasheet. http://www.ti.com/lit/ds/symlink/lm2576.pdf
Print
Go Up Pages1
User actions